28962
22
Zoom out
Zoom in
Vorherige Seite
1/75
Nächste Seite
22
0
25
50
75
100
02550
75
100
0
25
50
75
100
02550
75
100
S
e
r
v
o
T
r
a
v
e
l
S
e
r
v
o
T
r
a
v
e
l
Stick Deflection Stick Deflection
LINEAR THROW
EXPONENTIAL THROW
EXP (EXPONENTIAL)
The RD6000 Super allows the pilot to choose two settings for Exponential throw for each of the primary flight
channels, Elevator, Aileron (and Rudder in helicopter mode).
Exponential throw is primarily used to “soften” or decrease the control stick sensitivity of a control around the neutral
point. With Exponential disabled, a control funtion servo will move in an amount proportional to the amount of control
stick deflection, i.e., 50% stick deflection will result in 50% servo travel; 75% stick deflection will cause the servo to
travel 75% of it presently set maximun throw.
Exponential settings DO NOT change the amount of travel available at 100% stick deflection, but rather it changes
the amount of the servo travel that will occur with stick deflections less than 100%. The first 25% of stick deflection
may be set to result in only 10% of total servo throw making the control less sensitive around neutral. See the
following illustrations.
If you have used Exponential functions before, you will want to start with a small amount of Exponential (10 to 20%)
to determine wheather you like this sort of control response. Exponential is most useful where strong control response
is desired at extreme stick positions but softer response to small stick movement is desired in order to make very
accurate small corrections to flight path.
The switch positions for Exponential #1 and Exponential #2 correspond to the Dual Rate switch positions of Elevator
and Aileron. Exponential #1 is with the Dual Rate switch in the down i.e., Off position. Exponential #2 is with the Dual
Rate switch UP i.e.,ON position. (Note however that you can leave the Dual Rate adjustments for Elevator and Aileron
set at 100% which is no rate, so that switching a Dual Rate switch ON will activate Exponential only.
NOTE: Setting the Exponential with a positive number will make servo movement soft in the neutral area of the stick
movement. Setting the Exponential with a negative number will make servo movement faster in the neutral area and
softer at the end of the stick travel.
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Airtronics RD6000super wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info