Bedienungsanleitung Airwell RCW4 (Seite 8 von 20) (Englisch)

638709

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Under the single control mode, press

“Timer/Time” to go the timer setting

status.

Press the button of the weekday to select

the required weekday.

( to adjust the time period.

Press “Timer/Time” again to go to the

timer setting page.

5.3.4 Fan

When the unit is on, whether it is under single or centralized control, the fan speed will change cyclically

according to the following sequence by pressing “Fan”.

See Fig.5.7 for fan speed setting demonstration:

Auto Low Medium High

Confirm/Cancel

Mode

Fan

On/Off

24 68 10 12 14 16 18 20 22 24











11 12

13 14

15 16

CENTER

SUNM ON TUEW ED THUF RI SAT

AUTO

SUN

MON

TUE

WED

THU

FRI SAT

SHIELD

CHLD LOCKI

ERROR

ROOM

COM

SET

INNER UNIT

TEMP

MODE

ON/OFF

ALL

AllonAlloff

Confirm/Cancel

Mode

Fan

On/Off





THU

ROOM SET

AllonAlloff

Fig. 5.7 Fan Speed Control

5.3.5 Timer

The Timer, namely the weekly timer, has a one week cycle. The timer is enabled for on/off time settings

of the unit (measured in 0.5 hour units) for one or several days during a week with the option of several

time periods on the same day. The timer setting then preserves and repeats this setting weekly.

Introduction to the weekly timer:

a. Once the weekly timer is set, the unit will automatically be turned on/off as the set time starts/ends. For

instance, in the case that the current time is 9:00 Friday and the setting of the timer is as shown in the

figure below, the unit will turn on at 10:00, turn off at 10:30 and then turn on again at 12:30 and off at

13:30.

b. The weekly timer does not conflict with the manual on/off control, that is, the unit can be turned on/

off manually even if the weekly timer is set and the unit also can be turned on/off as according to the

setting of the weekly timer.

For instance, in the case that the weekly timer is set according to the figure below from 8:00 to 10:00 and

from 15:30 to 21:30, and the current time is 8:40 Friday and the unit is turned off manually, the unit will

be automatically turned on at 15:30 and later turned off at 21:30.

5.3.5.1 Setting the Weekly Timer under Single Control

In single control mode, it is possible to go to the weekly timer setting page by pressing Timer/Time. “*”

will flash (“*” indicates MON, TUE, WED, THU, FRI, SAT, or SUN). Press the weekday button to set the

weekday. After that, press Timer/Time

finally press Confirm/Cancel to confirm this setting (without pressing Confirm/Cancel, the setting will

not be saved). Similarly, several time periods in one day can be set. After the setting is finished, please

press Timer/ Time to quit or wait for the timer to exit automatically 30 seconds later.

See Fig. 5.8 for weekly timer setting demonstration under single control:

&(175$/:,5('&21752/&(175$/:,5('&21752/

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Airwell RCW4 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info