Bedienungsanleitung Akai GX-370 D (Seite 5 von 17) (Englisch)

752067

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

VOLTAGE & CYCLE CONVERSION

Voltage

This model is equipped with a built-in step-down trans-

former offering six stages of power voltage from 100 V to

240 V AC for world-wide operability. The voltage is preset

at the factory according to destination. However, the

operator is requested to check the setting prior to operation

and if necessary, adjust as follows: (A) Remove Fuse Post

by turning in direction of arrow. (B) Reset Voltage Selector

Plug so that proper area voltage shows through the Plug

cut-out. (C) Change fuse according to voltage: 100 V to

120 V: 1.5 A, 125 V fuse; 200 V to 240 V: 1 A, 250 V

fuse. (D) Tighten Fuse Post.

.Be sure to disconnect power cord before attempting to readjust

voltage.

.The line voltage should be held within a 10% deviation of

standard area voltage.

Cycles

Correct tape speed cannot be obtained if the Cycle

Conversion Switch on rear panel is not properly positioned.

Set to 50 Hz or 60 Hz according to area power source.

TAPE SPEED SELECTION

This model can be operated at either 7-1/2 or 3-3/4 ips tape

speed. Simply depress Tape Speed Selector Switch accord-

ing to desired speed. The recording time with an 1800 ft.

tape is as follows: (stereo) 3 hrs at 3-3/4 ips; 1.5 hrs. at

7-1/2 ips; (monaural) 6 hrs. at 3-3/4 ips; 3 hrs. at 7-

i/2 ips.

at the end of the tape), depress the Automatic Stop/

Shut-Gff Switch to IN position.

.If automatic shut-off is desired after one complete reverse cycle,

affix sensing foil to outside of tape at desired reversing point and

depress the Automatic Stop/Shut-Off Switch.

.If automatic continuous reverse is desired, apply sensing foil to

the outside of the tape for normal to reverse operation, and to

the inside of the tape for reverse to normal operation, at desired

reversing points and leave the Automatic Stop/Shut-Off Switch at

OUT position. Note that in this case, if the Automatic Stop/

Shut-Off Switch is depressed, automatic shut-off will be effected

at the end of one complete reverse cycle and the power of the

entire unit will be cut off.

.The AC Outlet at the rear of the recorder is inter-locked with the

Automatic Stop/Shut-off Switch so that if another machine is

connected to this outlet and the Automatic Stop/Shut-Off Switch

is depressed, the power of both units will be cut off when

automatic shut-off is effected.

DIRECT FUNCTION CHANGE SYSTEM

This model employs a direct function change control

system for speedy mode selection. The necessity of

depressing the Stop Key before changing modes is elimi-

nated. Further, the controls are equipped with individual

colored lights which indicate each operating mode.

.When extremely thin tape of over 2,400 ft. in length is used, to

avoid tape damage, it is imperative that the Stop Button be

depressed before changing modes.

FAST FORWARD & REWINU

For rapid forwarding of the tape, depress Fast Forward

Key, and for rapid rewinding of the tape, depress Rewind

Key. This feature enables fast selection of your favorite

programs.

AUTOMATIC STOP & SHUT-OFF

One of the exclusive features of this model is the automatic

stop and shut-off functions of the unit. For automatic stop

(to stop reel movement at the end of the tape), leave the

Automatic Stop/Shut-off Switch at OUT position. For

automatic shut-off (to cut off the power of the entire unit

[4]

PAUSE CONTROL

This model is equipped with a Pause Button for moment-

arily stopping recording or playback function. Pause

control is especially convenient for editing tapes; i.e., when

a certain portion of the program is not desired, depress the

Pause Button. Note that the Pause Indicator La~p will light.

Simply depress again to release.

REMOTE CONTROL

All operating functions of this model can be remote

controlled by using Akai Remote Control unit RC-16

optional accessory. Plugs into Remote Control Socket on

rear panel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Akai GX-370 D Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info