Bedienungsanleitung Akai GX-370 D (Seite 7 von 17) (Englisch)

752067

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

* Oil on capstan. Please refer to Pinch Wheel & Capstan

Cleaning procedure.

* Sticky or dirty tape surface.

* Tape is not loaded properly.

Does not turrt on eventhough the Power Switch is depressed

* Check AC Cord.

* Machine is set to automatic shut-off.

* Fu~e is blown.

The following notes are provided for your convenience.

* Place machine on a flat horizontal surface and operate

either horizontally or vertically.

* Do not place anything on top of your machine which

will obstruct the ventilator.

* Should there be a problem with your machine, write

down the model and serial numbers and all pertinent

data regarding warranty coverage as well as a clear

description of the existing trouble and contact your

nearest authorized Akai Service Station or the Service

Dept. of Akai Electric Company, Tokyo, Japan.

OPERATING PRECAUTIONS

The following conditions do not indicate mechanical failure

of your unit. If your machine exhibits any of the following,

check for trouble as indicated.

Loss of sensitivity and tone quality

* AC power voltage lower than the voltage to which your

machine is adjusted.

* Magnetized heads.

* Wrong side of tape facing heads, or defective or worn

tape.

Machine will not record or play

* Check positions of controls, input and output connec-

tions and plugs.

* Tape is not loaded properly.

* Machine is set to pause mode.

* Trouble with the connected machine.

Irregularity in tape transport

* When extremely thin tape of over 2,400 ft. in length is

used, to avoid tape damage, it is imperative that the

Stop Button be depressed before changing modes.

TAPE SELECTOR SWITCH

This model is equipped with a Tape Selector Switch. Use of

this switch brings out the maximum response of high

performance low noise tapes and works to change the

recording equalization according to the tape. The combi-

nation of the Akai GX Head and low noise tape has enabled

startling progress in tone quality. Use for low noise tape

only.

COMPUTE-o-MATIC (automatic recording

level control)

In the past, when making a recording, in order to obtain an

optimum recording level, the operator had to adjust the

input controls by hand while observing the VU Meters. The

new Akai Compute-O-Matic system does the job for you in

that when the Compute-O-Matic Set Button is depressed

during recording mode, the maximum sound level is

automatically adjusted to "0" VU and then other levels are

adjusted proportionately. In other words, when this button

is depressed, the Recording Level Indicator automatically

stops at maximum. This maximum level becomes "0" VU

and other levels are proportionately adjusted. Note that this

system differs from ordinary so called "automatic gain

control" systems which merely keep the sound within a

certain midrange level.

RECORDING LEVEL SElTlNG

For precise setting of the recording level, monitoring

through headphones is recommended. Connect stereo head-

phones to the Headphone Jack, and depress SOURCE

Seley tor Switch. Adjust the Recording Level Controls while

observing the VU Meters and keep the recording level as

high as possible within the yellow part of the meter scale.

* If SOURCE Selector Switch is depressed, the input level can be

adjusted before setting machine to recording mode. However, if

TAPE Selector Switch is depressed, the input level can be

adjusted only after setting machine to recording mode.

HOW TO USE THE DIN JACK

The Din Jack at the rear of the machine can be used instead

of the Rec. and P .B., Jacks if your amplifier has a

corresponding connection. This one cord system eliminates

the necessity of four separate connections and disconnec-

tions. When recording from an external amplifier, if the

output of the amplifier is more than 70 mY, set the Din

Jack High/Low Input Switch to HIGH position. If the

output level is less than 70 mY, set to LOW position.

* Do not use DIN-DIN Jack for connection with other tape

recorders or decks.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Akai GX-370 D Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info