Bedienungsanleitung Al-ko AL-KO 142 (Seite 33 von 124) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

594600

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

Starting / Stopping the engine

ENGLISH 13

7.3 Starting

Observe the safety instructions when starting.

Lay the brushcutter level and without obstructions on

the ground.

During starting, never stand or kneel on the shaft

tube, otherwise the shaft or the tube might be

damaged.

Take up a safe position, securely hold the machine

and ensure that the cutter does not touch any objects

or the ground.

When the engine is cold:

With the choke lever up ( ) and with the

decompression valve held down, start the engine

by pulling the starter handle up in a straight line

several times until the motor is briefly audible

(ignition).

Then immediately move the choke lever down ( ).

Continue to start (with decompression valve held

down) until the engine runs evenly.

When the engine is warm:

With the choke lever down ( ) and with the

decompression valve activated, start the engine by

pulling the starter handle up in a straight line several

times until the motor runs evenly.

Note: Under good conditions, the engine will already

start under idling throttle if it is at operating

temperature. (If a part throttle stop is set it will be

cancelled by operation of the throttle control even if

the engine is at standstill.)

Starting with the stop switch in mid-position

If the engine will not start under idling throttle, set a

part throttle stop in the way described above.

If the engine is running in part throttle operation:,

briefly pull the throttle back to release the half throttle

detent. Release the throttle lever again to allow the

engine to run at idle speed. Now you can commence

working.

7.4 Turning off the engine

Release the throttle and push the stop switch to

”STOP”.

Important: Due to the centrifugal clutch, the cutter

will run on for a short time, even if you release the

throttle. Ensure the cutter has come to a full standstill

before storing the machine.

Summary of the key points in the startup process:

• Position the engine safely on level ground,

• If necessary press the primer several times,

• Use the stop switch and the throttle control to

set a part throttle stop.

• Cold start:

o Set the choke lever to , press the

decompression valve and turn the engine until it

fires for the first time,

o Then set the choke lever to ,

o Keep starting until the engine starts to run.

• Warm start:

o Set the choke lever to , press the

decompression valve and start the engine

until it starts to run.

• Once the engine is running, briefly pull the throttle

control to cancel the part throttle stop.

7.5 Engine will not start

If the engine fails to start after several attempts,

check whether all adjustments described above have

been correctly carried out, particularly that the stop

switch is not in the "STOP" position. Try starting once

again. The combustion chamber will be flooded, if the

engine still fails to start.

In that case we recommend you proceed as follows:

• Remove the spark plug cover.

• Pull the spark plug cap off the spark plug.

• Remove the spark plug and dry fuel mixture from

the electrodes.

• Move the throttle lever up to full throttle. Pull the

starter handle several times (with removed spark

plug) to clear the combustion chamber.

• Move the throttle lever down to idling position, refit

the spark plug, the plug cap and the plug cover.

Start the engine with the choke lever down ( ) and

the stop switch in the "Start" position.

7.6 Additional notes on correct handling of

the starter

The following instructions are aimed at increasing the

service life of the starter rope and of the starter

mechanism:

• Always pull the rope out in a straight line.

• Do not let the rope drag across the edge of the

rope eyelet.

• Do not pull rope all the way out - risk of the rope

breaking.

• Always manually guide the rope back into its start

position with your hand on the starter grip - do not

let it retract on its own.

A specialist can replace a damaged starter rope.

Fig. 12

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Al-ko AL-KO 142 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info