Bedienungsanleitung Al-ko AL-KO BC 4535 II-S Premium (Seite 19 von 260) (Alle Sprachen)

594329

Zoom out

Zoom in

Vorherige Seite

1/260

Nächste Seite

Startup

440 247_a 19

6. Once the engine has started: set the choke to

“RUN”.

7. Pull out the starter cord until the engine starts.

8. If the engine fails to start, please repeat steps

1-7.

Warm start

1. ZSet the ignition switch to “Start".

2. Set the choke to “RUN”.

3. Lock the gas lever as described under “Cold

start”.

4. Pull the starter cord a maximum of 6 times.

➯

the engine starts.

5. Keep the gas lever pressed down until the en-

gine runs smoothly.

Engine does not start

1. Set the choke to the “RUN” position.

2. Pull the starter cord 5 times.

If the engine still does not start

1. Wait 5 minutes and then try again with the gas

lever pressed down.

OPERATION

Always let the engine run in the upper speed

range during trimming and cutting.

Safety instructions

CAUTION!

Please observe the safety and warning

notices in this manual and on the pro-

duct.

CAUTION!

During extended periods of use the vi-

brations can cause disorders of the

blood vessels or nervous systems of the

fingers, hands and wrists. You may ex-

perience parts of your body going numb,

twinges, pains or changes in the skin.

If such symptoms arise, please consult

your doctor!

Never hold the string head higher than knee

level when the device is in operation.

Never work on a slippery hillside or slope.

When mowing on sloping ground, always

stand downhill of the cutting device.

Never use the device in the vicinity of highly

flammable liquids or gases – Risk of fire and/

or explosion!

After contact with a foreign object:

Switch off the engine.

Examine the device for damage.

Persons who are not familiar with the trim-

mer should practise handling it with the en-

gine switched off.

Avoiding recoil

CAUTION!

Risk of injury from uncontrolled kick-

back!

Do not use cutting blade near solid obst-

acles.

Dense vegetation, young trees or brushwood can

jam the cutting blade and stop it turning.

Avoid jamming by noting the direction in

which the vegetation leans and then cutting

from the opposite side.

If the cutting blade becomes entangled during

cutting:

Switch off the engine immediately.

Hold up the device so that the cutting

blade does not jump or break.

Push the caught material away.

Trimming

1. Examine the terrain and determine the desi-

red cutting height.

2. Guide and hold the string head at the desired

height.

3. Swing the device from side to side in a

sweeping, scythe-like motion.

4. Always keep the string head parallel with the

ground.

Close trimming

1. Hold the device so that it is tilted forward at a

slight angle and moves just above the ground.

2. Always trim away from your body.

Trimming along fences and foundations

CAUTION!

Risk of injury from uncontrolled kick-

back!

Do not use cutting blade near solid obst-

acles.

1. Move the device slowly and with care, ensu-

ring that the string does not impact with obst-

acles.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Al-ko AL-KO BC 4535 II-S Premium Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info