Bedienungsanleitung Alber e-motion M25 (Seite 9 von 41) (Englisch)

785808

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

1.6 Permissible conditions of use/locations of operation

•Observe the permissible conditions of use of the wheelchair to which the e-motion wheels are attached (see wheelchair operating manual).

•In addition to observing the information provided on the e-motion, it is also imperative to observe the information provided by the

wheelchair manufacturer (e.g. maximum gradeability, maximum permissible height of obstacles, maximum user weight, maximum speed,

etc.). The lowest values always apply.

•Any limits regarding the operation of the wheelchair (e.g. maximum gradeability, maximum permissible height of obstacles, maximum

user weight etc.) must also be observed when using the e-motion.

•The e-motion must only be used at temperatures between -20°C and +50°C. As such, avoid exposing the e-motion to any heat sources

(such as intense sunlight), since this may cause its surfaces to reach high temperatures.

•Avoid using the wheelchair on soft ground (e.g. loose chipping, sand, mud, snow, ice or deep puddles).

•Take particular care to observe the safety instructions and hazard information provided in chapter 3.

Never drive without anti-tippers, and only remove them in order to drive over major obstacles. It is left to the judge-

ment of the driver whether to call an attendant for help when there is an increased risk that the wheelchair may tip

over.

Travelling without a pair of anti-tippers increases the risk of accidents, and thus injuries.

Alber GmbH accepts no liability for accidents caused by operation of the e-motion without a pair of anti-tippers.

The execution of “wheelie” movements (anti-tippers removed from wheelchair, e-motion wheels on the ground, front

wheels (castors) up in the air) is not permitted. Alber GmbH accepts no liability for accidents resulting from such

actions.

Especially when it is not in use, avoid exposing the e-motion to strong sunlight for long periods of time wherever

possible. This could cause the motor to heat up and, in extreme cases, prevent it from operating at full power.

Plastic parts also age quicker under intense sunlight.

In case of overheating: allow the wheels to cool down for at least 60 minutes.

1.7 Standard scope of delivery

•Two e-motion wheels

•One battery charger

•This operating manual

The wheelchair must have special brackets to attach the e-motion wheels. If this is not the case, please contact your specialist dealer or

an Alber agent.

1.6 The main elements at a glance

(please fold out overview drawing in document cover)

Wheel

LED displays 1

On/off button with charger socket 2

Stub axle locking mechanism 3

Wheel casing 4

Push rims 5

Sensor 6

Fins (rear of wheel) 7

Stub axle 8

Wheelchair (not included in scope of delivery)

Bracket with wheel retainer 9

Wheelchair parking brake 10

Charger

Charging plug 11

LED display 12

Charger housing 13

Mains plug 14

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alber e-motion M25 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alber e-motion M25

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info