Bedienungsanleitung Alber e-motion M25 (Seite 10 von 41) (Englisch)

785808

Zoom out

Zoom in

Vorherige Seite

1/41

Nächste Seite

2. Commissioning

The e-motion wheels and any accessories you have ordered will be fitted to your wheel-

chair by Alber or your specialist dealer and delivered ready for operation. To this end,

there are new brackets [9] on both sides of your wheelchair with wheel retainers for

the two e-motion wheels to be inserted into (see chapter 2.1). Please keep the manual

wheelchair wheels you have used until now so that they can be used again if needed.

On delivery of your e-motion, your specialist dealer will show you how to operate the

system and any accessories you have ordered. You will also be given this operating

manual which, in addition to the technical information, also contains important driving

instructions.

The brackets [9] must be attached to the wheelchair by Alber or its

authorised specialist dealers.

Regularly check the brackets [9] to ensure that they are firmly

secured to the wheelchair. If a screw connection has become loose,

contact your authorised specialist dealer to have it retightened.

Alber GmbH provides brackets of various design (single-part or mul-

tiple-part brackets). As such, the brackets shown in the diagrams of

this operating manual may vary from those attached to your wheel-

chair.

The wheelchair’s parking brakes [10] have been calibrated to work

with the e-motion wheels. If you go back to using manual wheels

on your wheelchair, the parking brakes will need to be recalibrated

accordingly.

Speed limitation in neutral gear (without motor assistance)

When operating the e-motion wheels in neutral, a speed of 20 km/h

can reached without any problems. This will cause no damage to the

electronic or mechanical systems, as they are designed to handle

this load case. At higher speeds (e.g. travelling downhill in neutral;

use of hand bikes, in particular with motor assistance or electric

motor towing devices), much higher speeds for which no tests are

required by the standard guidelines can be reached. The standards

only stipulate that the additional drive has to be tested up to its

maximum motor-assisted speed for the relevant load cases. However,

some wheelchair manufacturers limit the maximum permitted speed

to values below 10 km/h. In any case, the speed limitation as stip-

ulated by the wheelchair manufacturer must be adhered to if it is

specified in the instructions for use for the wheelchair. For your

own safety, we recommend that you do not exceed the specified

maximum speed of the additional drive or wheelchair (whichever is

the lowest value) during daily use. We assume no liability for any

damage which results from operation at speeds higher than the stip-

ulated maximum speed.

The e-motion wheels must be switched off if a hand bike or towing

device is used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alber e-motion M25 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alber e-motion M25

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info