Bedienungsanleitung Alecto DVM 70 (Seite 9 von 20) (Englisch)

458285

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

4 USAGE

4.1 SWITCHING ON/OFF:

• Brieypressthe button to switch the unit on.

• Keep this button pressed for 2 to 3 seconds to switch the unit off.

4.2 CONNECTION INDICATOR:

• As soon as the monitor unit is switched on, the connection indicator ashesrapidly

and the monitor unit starts searching for the camera unit. Once the camera unit has been

found,thisindicatorwilllightcontinuouslyorwillstartashingataslowpace.

4.3 MONITOR UNIT VOLUME:

• Press the

VOL

button repeatedly to increase the receiver volume.

• Press the

VOL

button repeatedly to reduce the receiver volume.

• If the screen is switched on, the volume level is displayed at the top: = max vol-

ume, = min volume, = sound off

• If you have switched off the sound, the lamp also lights up. This gives you an indication

that you have turned off the sound, even if the video is switched off.

• when the max. or min. value is reached, 3 short beeps will be heard

if you have switched on the vibrating alarm (see section 6.3), the vibration will be

activated as soon as you turn the sound off, as a conrmation that the ‘vibrating alarm’

function has been enabled

if ‘Zoom in’ (see below) is enabled, you cannot adjust the volume; switch ‘Zoom in’ off

rst

ATTENTION: When your baby is sleeping and the baby-unit does not hear any sound, the loud-

speaker of the parents-unit will be switched off, irrespective the volume setting. As soon as the

baby makes any noise, the loudspeaker will be switched ON again.

4.4 ZOOM IN:

• Press the button to see a close-up of the image.

• Use the or or or buttons to move up, down, left or right.

• Press the button again for normal viewing.

4.5 SWITCHING THE VIDEO OFF:

• If ECO mode is not enabled, the video is transmitted continuously. You can turn this off by

pressing the button. This does not affect the sound.

• Press any button on the monitor unit to switch the video back on again.

• As soon as one of the alarm functions is activated (see Chapter 6), the video is also

switched on.

4.6 TALKBACK:

• Press the button to talk back to the camera unit. You can talk for as long as you hold

the button pressed down. On the camera unit, you can adjust the volume with the + and -

buttons.

• If you have activated the lullabies, they will be temporarily interrupted during the talkback.

4.7 RECEPTION INDICATOR / OUT OF RANGE MESSAGE:

• In the upper left-hand corner of the image on the monitor unit, there is an indication of the

strength of the signal being received from the camera unit.

: very good reception, : standard good reception, : reasonable reception

• In all cases, the audio and video quality is shown with the same level.

• Assoonasthesignalstrengthisinsufcienttoreceiveaudioandvideo(only lights up),

the warning ‘NO LINK’ appears in the image. After a few seconds the screen goes black,

andtherangelightstartsashingrapidly.

• If any button on the monitor unit is pressed, the screen lights up with the message ‘Waiting

for connection...’. After approximately 10 seconds, the screen goes black again.

• As soon as the monitor unit and the camera unit are back in range of each other, the im-

age lights up continuously.

the same happens if the camera unit is switched off with the on/off button or if the bat-

teries become empty in the case of mobile use

4.8 LULLABIES:

You can play lullabies from the camera unit. You can start and stop these lullabies both directly

on the camera unit and via the monitor unit.

Camera unit:

• Press the button to start the lullabies.

• Lullaby 1 is played repeatedly for 15 minutes.

• Press the button to select a different lullaby.

• Adjust the volume by pressing the + and - buttons.

• The lullaby stops playing automatically after 15 minutes, or you can stop it before that

time by pressing the button.

it is not possible to enter a setting on the camera unit to play all the songs, the select-

ed song is played repeatedly for 15 minutes

Monitor unit:

1. press the M button to open the menu

2. scroll with or to the ‘LULLABY’ option

3. press the M button

4. use or to select the desired lullaby or select ‘All’ to play all the songs one after an-

other

5. press the M button

6. use or to select the option ‘Play’

7. press the M button, the lullaby starts playing

8. repeat the above instructions, but in step 6 select the option ‘Stop’ to stop the lullaby

playing

the lullabies are played for 15 minutes and stops automatically

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto DVM 70 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Alecto DVM 70

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info