794954
5
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
USER MANUAL INTRODUCTION
The Alecto FR-115 is a PMR-446 walkie-talkie.
This walkie-talkie allows you to not only commu-
nicate with each other free of charge, but also
with other (Alecto) walkie-talkies provided they
meet the PMR-446 standard.
DISPLAY FUNCTIONS
VOX = Voice Controlled Transmitting
SCAN = Channel Scan
Channel number
CTCSS subcode
= Standby
Battery level = receiving
= Sending
Key lock
Set volume level
FUNCTIONS INSTALLATION
POWER:
The FR-115 is powered through 3x AAA penlite
batteries.
1. Open the battery compartment by pressing
the tab at the bottom of the battery cover
upwards, the battery cover can then be
removed.
In order to avoid the risk of
suffocation when used by small
children, because the belt clip is
a relatively small part, the belt clip
has been glued by the factory.
Removal and re-installation of the
battery cover may be more difficult.
2. Install the batteries according
to the markings in the battery
compartment and close the
battery compartment.
HEADSET:
On top of the FR-115 you’ll find the connector
for a headset with a 2.5mm plug. We advise you
to use an Alecto FRH-10 headset for this.
USE
Attention: for a connections between 2
walkie-talkies, both walkie-talkies must
be set to the same channel, with the same sub-
code. See further on in this manual how to set
the channel and sub-codes.
TO SWITCH ON/OFF:
Press and hold the button for 2 seconds to
switch the walkie-talkie on or off.
VOLUME CONTROL:
Repeatedly and briefly press the or button
to adjust the volume. The set volume level is
shown in the lower part of the display.
TO SEND:
Press the P button to send. Keep this button
depressed while speaking. Talk at a normal
voice volume and approximately 3 to 5 cm from
the walkie-talkie’s microphone.
TO RECEIVE:
Release the P button to receive.
CALL ALERT TONE:
Press the P button briefly to transmit a call alert
tone. This call alert tone is adjustable, see ‘To
change the call alert tone’ further on in this
manual.
BACKGROUND LIGHTING:
Each time you press a function button (except
the flash light button) the background lighting of
the display will illuminate. This lighting will auto-
matically switch off 10 seconds after pressing
the last button
FLASH LIGHT:
Use the button to switch on the built-in flash
light. This light remains lit for as long as you
keep this button depressed.
The walkie-talkie doesn’t need to be switched
on to use this function.
Attention: Don’t stare directly into the light when
lit and don’t shine it in other people’s eyes.
The light can be bright and may damage your
eyesight.
ADDITIONAL FUNCTIONS
VOX FUNCTION:
When the VOX function is enabled (VOX =
Voice Activated Transmission), the FR-115 starts
sending as soon as you speak into the micro-
phone.
To switch the VOX function on/off:
1. press 3x the MENU button, the word “VOX”
will illuminate in the left part of the display
2. use the buttons or to set the trigger sen-
sitivity (‘OF’ is off, ‘1’ is the lowest sensitivity,
‘3’ is the highest sensitivity)
3. press the P button to confirm
Preferably, use this function in combination with
headsets. Keep in mind that it can take over a
second after you’ve started talking before the
walkie-talkie enables the transmitter.
CHANNEL MONITORING: (listening)
Use this function to disable the noise reduction,
allowing you to also listen to weak transmitters
on the current channel.
To switch the MONITOR function on/off:
1. press and hold the button for 2 seconds to
disable the noise reduction and to monitor the
channel
2. release the button to turn the noise reduc-
tion on again
CHANNEL SCAN:
Use the scan function to listen in on all channels
one after the other.
1. Press and hold the button for 2 seconds to
start the scan
2. briefly press the or button to continue
scanning if you’re only receiving noise on a
certain channel
3. press the P or MENU button to end the scan
KEYPAD LOCK:
When the keypad lock is activated, the , and
MENU buttons are blocked.
1. press and hold the MENU button until
appears in the display after approx. 2 sec-
onds
2. press and hold the MENU button again for
2 seconds to release these buttons again
SETTINGS
TO CHANGE THE SEND/RECEIVE
CHANNEL:
1. press 1x the MENU button and the channel
indication starts flashing
2. press the or button to select the desired
channel
3. press the P button to confirm
TO CHANGE THE SUB-CHANNEL (CTCSS):
1. press 2x the MENU button and the sub-chan-
nel indication starts flashing
2. use the or button to set the desired
sub-channel (1-38) or disable this function by
selecting OF
3. press the P button to confirm
Keep in mind that the walkie-talkie at the receiv-
ing end must be set to the same sub-channel.
Sub-channel explanation, (CTCSS code):
Continuous Tone Controlled Squelch System
is a tone code that’s included while transmit-
ting. This tone code is not audible. Only when
the tone code of the transmitting walkie-talkie
matches the tone code of the receiving walkie-
talkie, the receiving walkie-talkie will reproduce
the signal. This prevents you from being dis-
turbed by other PMR-446 walkie-talkies commu-
nicating on the same channel.
SCAN
VOX
Microphone
Flash light
Headset output
Antenna
Display
P button
(send button)
Charging contacts
(rear)
Speaker
SCAN
VOX
HI
LO
MENU
1.5V AAA
1.5V AAA
1.5V AAA
FR-115
FR115
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Alecto FR115 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info