Bedienungsanleitung Alecto WS-3300 (Seite 35 von 42) (Deutsch, Englisch, Holländisch, Französisch)

708524

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

chance of frost

When the weather station has received the outdoor sensor’s signal, it’ll automatically switch to the reception

of the DCF-77 atomic time.

2.4 (DCF) time:

When the 

atomic time radio graphically sent by the ‘DCF77’ station, the symbol will remain lit. If this symbol doesn’t

appear, the time is shown via the internal clock of the weather station. The DCF77 station is situated in

Frankfurt, Germany. The reception of the DCF77 time is basically possible in the whole of Western Europe.

During daylight saving time, ‘DST’ will appear underneath the symbol.

2.5 Pairing the weather station / outdoor unit:

Automatically:

As soon as the batteries are installed in the weather station, the weather forecast animation icon starts

flashing. Use the ▼and ▲ buttons on the front panel of the weather station to input the actual weather type.

After 1 minute the weather stations enters the reception mode from the outdoor unit and starts searching

for a signal from the outdoor unit. Therefore, if you insert the batteries into the outdoor unit within that

minute and the units will ‘find’ each other, they will be automatically paired and the display of the weather

station will show the temperature transmitted by the outdoor unit. The weather station will then switch to

the reception of the DCF-77 time signal to synchronise with the station in Frankfurt (see Clock).

Manually:

If the units cannot be paired automatically, or after replacing the batteries, you can pair the outdoor unit

(again) with the weather station unit as follows:

1. press and hold the ▲ button on the weather station for 2 seconds until the

antenna



 

3. the units will have found each other (again) after several seconds

3. POSITIONING THE OUTDOOR UNIT

When the outdoor unit is registered on the weather station and everything is working properly, you may

place the outdoor unit with outdoor sensor (wind and rain sensor) outside.

Because the outdoor sensor and outdoor unit are connected with a cable, the outdoor unit may be placed

closer to the weather station (max. distance 30 meters) or at eye-level to easily read the outdoor unit.

In case of wall-mounting, the weather station and outdoor unit may be suspended from a single screw. You



3.1 Outdoor unit placement tips:

To have the rain and wind meter function as accurate as possible, the rain and wind meter must be placed

exactly horizontal.

3.2 To set the wind meter:

To be able to indicate from which direction the wind is blowing, the rain and wind unit must face the North.

Make sure that the wind vane is aimed to the front (the rear of the wind vane is located above the arm and

closest to the rain sensor. for this, see the “direction for setting wind vane” marking above the rain and wind

meter. Use an accurate compass (not included) to properly aim the unit.

The wind rose will indicate the wind direction. When the outdoor wind meter is installed correctly, the wind

direction may be activated as follows.

Press and hold the “MODE/SET” (30) button for at least 1 second until



Then press the “MODE/SET” (30) 14 times until the wind rose starts

▲ and ▼ buttons to set the North. The settings menu

closes after 15 seconds without pressing any buttons or you may press the

“MODE/SET” (30) button.

Weather conditions:

When the animation indicates rain, but one of the temperature displays is below 0°C,

snow will be displayed in the animation.

Frost alert:

The frost alert icon

will appear in the display when the outdoor temperature is be-

tween -2°C and +3°C.

°C/°F

RESET

OPEN

reset

in line

North

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Alecto WS-3300 Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info