Bedienungsanleitung Allen-Heath MixWizard Series WZ20S (Seite 11 von 32) (Englisch)

541378

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

WZ20S User Guide 11

NO USER SERVICEABLE PARTS INSIDE.

SUPPLY VOLTAGE RANGE:

100 - 240V

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

47-63Hz ~ 30W MAX

WARNING - THIS APPARATUS MUST BE EARTHED.

REFER TO USER GUIDE BEFORE CONNECTING SUPPLY

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK

DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.

AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.

REPLACE FUSE WITH SAME TYPE AND RATING

WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE

ATTENTION: REMPLACER LE FUSIBLE AVEC UN DES MEMES CARACTERISTIQUES.

100 - 240V~ T500mA 250V 20mm

CAUTION

FUSE

OFF

AC MAINS IN ~

Connecting Mains Power

Read the SAFETY INSTRUCTIONS printed at the

front of this User Guide. Check that the correct

mains lead with moulded plug has been supplied

with your console. The power supply

accommodates mains voltages within the range

100-240V without changing any fuses or settings.

It is standard practice to turn connected power

amplifiers down or off before switching the

console on or off. Ensure that the IEC mains plug

is pressed fully into the rear panel socket before

switching on.

Earthing

The connection to earth (ground) in an audio system is important for two reasons:

1. SAFETY - To protect the operator from high voltage shock, and

2. AUDIO PERFORMANCE - To minimise the effect of earth

(ground) loops which result in audible hum and buzz, and to

shield the audio signals from interference.

For safety it is important that all equipment earths are connected to mains earth so that

exposed metal parts are prevented from carrying high voltage which can injure or even kill

the operator. It is recommended that the sound engineer check the continuity of the

safety earth from all points in the system including microphone bodies, guitar strings,

connector cases, equipment panels and so on.

The same earth is also used to shield audio cables from external interference such as the

hum fields associated with power transformers, lighting dimmer buzz, and computer

radiation. Problems arise when the signal sees more than one path to mains earth. An

‘earth loop’ (ground loop) results causing current to flow between the different earth paths.

This condition is usually detected as a mains frequency audible hum or buzz.

To ensure safe and trouble-free operation we recommend the following:

• Have your mains system checked by a qualified electrician. If the supply earthing

is solid to start with you are less likely to experience problems.

• Do not remove the earth connection from the console mains plug. The console

chassis is connected to mains earth through the power cable to ensure your safety.

Audio 0V is connected to the console chassis internally. If problems are encountered

with earth loops operate the audio ‘ground lift’ switches on connected equipment

accordingly, or disconnect the cable screens at one end, usually at the destination.

• Use low impedance sources such as microphones and line level equipment rated at

200 ohms or less to reduce susceptibility to interference. The console outputs are

designed to operate at very low impedance to minimise interference problems.

• Use balanced connections where possible as these provide further immunity by

cancelling out interference that may be picked up on long cable runs. To connect an

unbalanced source to a balanced console input, link the cold input (XLR pin 3 or jack

ring) to 0V earth (XLR pin 1 or jack sleeve) at the console. To connect a balanced

console output to an unbalanced destination, link the cold output to 0V earth at the

console.

• Use good quality cables and connectors and check for correct wiring and reliable

solder joints. Allow sufficient cable loop to prevent damage through stretching.

• If you are not sure ... Contact your service or local Allen & Heath agent for advice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Allen-Heath MixWizard Series WZ20S Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info