End point adjustment
(1) Access the function menu (By pressing “Exit” and “Enter” buttons
simultaneously and holding them down for one second), press “(+)” button twice to choose EAP function.
(2) Press “Enter” button to get into EPA function interface, use “(-)” or “(+)” button to select the desired
setting item , press “Enter” key, the initial value of your selected setting item will blink, then you can press
“(-)” or “(+)” button to adjust the value of your selected setting item. (Note: In the interface of adjusting the
value, return to the initial value "100%" by pressing “(-)” and “(+)” buttons simultaneously for about 1
second.)
(3) Press “Enter” button, the adjusted value of your selected setting item stops blinking, now the value of
your selected setting item has been set.
(4) Return to the initial screen by pressing “Exit” button twice.
4.5 Steering EXP "STEXP“
This function is used to change the sensitivity of the steering servo around the neutral and both ends
position. It has no effect on the maximum servo travel. Adjust the sensitivity of direction wheel both in
neutral position and ends.
Setup Item
RATE: Steering EXP rate
Adjustment range: -100% ~ 0% ~ +100%
Initial value: 0%
0% ~ -100%: Sensitivity around neutral position is low, getting higher
when approaching ends.
0%: Sensitivity around the neutral and ends position is equal
0%~ + 100%: Sensitivity around neutral position is high, getting lower
when approaching ends
