Bedienungsanleitung Arcam A38 (Seite 13 von 76) (Deutsch, Englisch, Holländisch, Französisch)

578745

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

E-11

English

Adjusting listening settings

e A38 allows you to customise various features of the

amplier to t your system. Use this diagram to help you

navigate through the available conguration options.

In the diagram, the control knob is shown as .

Normally, the display shows the current volume and the

control knob is used to adjust this.

Press MENU once to enter the setup menu, then press

OK repeatedly to cycle through the menu items. When

A38 setup

you have found the setting that you wish to adjust (as

shown on the front panel display), you can change the

setting using the control knob. Press MENU to store the

change and return to volume display mode – or press

OK again to move to the next setting.

Note that the menu will time-out aer a short period

without pressing a button, with the display reverting to

the current volume.

e following items can be adjusted from the setup

menu:

Conguring your A38 amplier

Balance

is allows you to adjust the output balance between le and right channels. e display is

also available directly by pressing the front panel DISPLAY button.

Volume resolution

ere are three volume-display options to chose from: ‘Standard’, ‘Fine’ or ‘Reference’.

Standard and Fine represent dierent levels of volume-control sensitivity; the Reference

setting gives absolute increments in 0.5dB steps.

Input trims

Input trims are used to compensate for variations in output levels of dierent source

equipment. If, for example, your CD player is louder at a given volume display value

than other inputs, you can attenuate it by using this setting so that it matches your other

components.

Use the source-select buttons to select the input you wish to adjust, then the control knob

to set (increase or decrease) the input volume for that source.

Max on volume

is can be used to limit the maximum volume the amplier operates at when it is rst

switched on: the A38 comes on at the (reduced) ‘Max. On Volume’ level if the last-used

volume exceeds this value.

If this item is set to ‘Disabled’, the A38 always comes on at the last used volume, even if this

is very loud.

Processor mode

Processor mode enables you to x the gain (volume setting) of your A38. e A38 (in

combination with a power amp.) can then be used to drive the front le and right speakers

of a surround-sound system, when fed from a separate processor. e volume of the entire

system can then be controlled using the processor.

Feed the sound from the processor into the AV input, then set the gain of the A38 to match

the ampliers that drive your other loudspeakers.

Reset

Conrming ‘Yes’ restores all amplier settings to their factory defaults.

‘Power On’ state

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam A38 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info