Bedienungsanleitung Arcam A38 (Seite 11 von 76) (Deutsch, Englisch, Holländisch, Französisch)

578745

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

E-9

English

Single wiring

Both the A38 and P38 are designed for bi-wiring, which is why there are duplicate speaker

terminals on the back. For single wiring, we recommend that you use the lower set of

speaker terminals on your amplier. If each speaker has more than one pair of connecting

terminals, use the terminals labelled LF or ‘Low Frequency’ for each speaker.

Connect the positive terminal of the right speaker connection on the amplier (coloured

red and labelled +R) to the positive terminal of your right speaker. Similarly, connect the

negative terminal of the amplier (coloured black and labelled with R) to the negative

terminal of your speaker. Repeat the process for the le speaker, using the amplier

terminals labelled +L and L.

If your speakers support bi-wiring, then there is a strip of conductive metal on the

speakers connecting the low-frequency terminals to those for the higher-frequencies; this

MUST NOT BE REMOVED in a single-wired system.

Bi-wiring

Bi-wiring is performed in the same way as single wiring except that, for each speaker, a

pair of cables are used to connect the amplier to each speaker.

Follow the instructions given for single wiring; then perform the same actions, this time

connecting the upper set of speaker terminals on your amplier to the terminals labelled

HF or ‘High Frequency’ for each speaker. Please refer to the illustration.

Speakers that support bi-wiring have a strip of metal on the speakers connecting the low-

frequency terminals to those for the higher-frequencies; this MUST BE REMOVED in a

bi-wired system.

Bi-amping

Bi-amping requires the use of two ampliers per channel. Normally, your A38 is used to

drive the high-frequency (treble) speakers, while a power-amplier (such as a P38) is used

for the lower (bass) frequencies.

Connect your A38 to the speakers as described for single wiring, with the exception that

the A38 should be connected to the speaker terminals labelled HF or ‘High Frequency’.

en connect the power amplier (P38, for example) to the LF or ‘Low Frequency’

terminals, as in the diagram. A pair of audio interconnect cables are also required to

connect the pre-amp outputs of the A38 to the power amp inputs of the P38.

Note that the strip of metal on the speakers connecting the lower terminals to the

upper terminals MUST BE REMOVED. Failure to do so will result in damage to both

ampliers, which will not normally be covered under warranty.

An A38 or P38 connected to speakers using single wiring











An A38 or P38 connected to speakers using bi‑wiring











An A38 and P38 connected to speakers using bi‑amping



















Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam A38 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info