Bedienungsanleitung Arcam DiVA AVR280 (Seite 21 von 38) (Englisch)

578769

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

AVR280

English

Operating your AVR280

For information display we recommend you use the OSD on your TV/screen whenever possible. However,

all key information is also duplicated one line at a time on the front panel display of the AVR280.

Switching on/off

Press the POWER button in. After approximately two seconds, the power LED will turn green and the

current input and volume level will be shown; after a further 10 seconds, the AVR280 is ready for use.

Please wait until the unit has nished initialising before attempting to operate the AVR280. It is

recommended that if the unit is switched off, you should wait at least 10 seconds before switching the

unit back on.

Stand-by

The AVR280 has a stand-by mode which can be entered by pressing the green stand-by button on the

remote control. When in stand-by mode the display is blank and the power LED glows red. If you do not

wish to put Zone 2 into stand-by at the same time as the main zone, press and hold the stand-by button

on the remote control for about 3 seconds. After this time, the front-panel of the AVR280 will display the

text ‘Main Off’, before going into stand-by; the LED for Zone 2 will be illuminated to show that Zone 2 is

still operating.

When not being used, the AVR280 may be left in stand-by mode, as power consumption is low. If you

are not using your AVR280 for several days, however, we recommend you switch the unit off completely

using the front panel power button.

To switch on from stand-by, press one of the source buttons on the front panel or on the remote control,

or use the stand-by button on the remote control.

Volume control

To adjust the volume level of the loudspeakers, pre-amp outputs and headphones use the volume

control knob. The volume level is shown on the display. Note that different sources may require different

settings of the volume control to achieve the same perceived volume level.

It is important to realise that the value indicated for the volume level is not an accurate indication of

the power delivered to your loudspeakers. The AVR280 may deliver its full output power long before the

volume control reaches its maximum position, particularly when listening to heavily recorded music.

In comparison, some movie sountracks can appear to be very quiet, as many directors like to keep the

maximum levels in reserve for special effect sequences.

The volume can be controlled over a range of 100dB in 1dB steps.

Muting the volume

Pressing the MUTE button will mute the output of the AVR280 to the speakers and from the ‘pre-amp

out’ connectors (the output to the record loops remains unaffected). ‘MUTE’ will be shown on the display

while in this state.

Press MUTE for a second time (or adjust the volume) to exit the mute state.

Front panel display

In normal operation, the display shows the current volume setting; smaller illuminated areas indicate the

audio input type (digital or analogue) and the digital stream type (if applicable). If the processing mode

changes (for example, from Dolby Pro Logic decoding to Dolby Digital 5.1), then this will be displayed ‘in

large letters’ for about 2 seconds.

Changing the display brightness (the DISPLAY button)

It is possible to select the illumination level of the front panel display. Press DISPLAY on the front panel

or DIS on the remote to cycle through the three illumination levels (Off/Dim/Bright).







 









 



 

  

  









      

     



 





Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam DiVA AVR280 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info