Bedienungsanleitung Arcam DiVA T61 (Seite 4 von 12) (Englisch)

578786

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

T61

Installation

T61 rear panel

Socket for IEC power inlet line

Voltage selector switch

Remote control input

Power On/Standby trigger in

AM step switch

Positioning the unit

Always place the tuner on a level, ﬁ rm surface.

Setting up the tuner

AM step switch

The AM tuning ‘step size’ needs to be set according to your

location. This is done using the switch on the rear panel: set

it to 10kHz if you are in North America, or 9kHz anywhere

else. This switch also ensures correct reproduction of FM

broadcasts for your location.

AM aerial

An AM aerial is required to receive AM/Medium Wave radio

signals.

An external AM loop aerial is supplied as an accessory. This

should be attached to the AM Antenna inputs with one end

connected to AM

and the other to Ground

. It does not

matter which way round this aerial is ﬁ tted. Rotate the aerial to

discover which position gives the best reception.

In areas of weak reception or when the receiver is used inside

a steel framed building (such as an apartment building) you

can use a wire between 3 and 5 metres long to strengthen

reception. Mount this high up outside the building, if possible,

and connect one end of this wire to the AM antenna input

as well as the loop aerial supplied. DO NOT DISCONNECT THE

LOOP AERIAL.

123 654

AUDIO

OUTPUTS

AERIALS

FM 75Ω GND AM

POWER INLET

120V 230V

789

IR IN

12V

TRIGGER

AM STEP

Audio output phono sockets, two

pairs

FM coaxial plug

Ground socket (for AM loop aerial)

AM socket (for AM loop aerial)

FM aerial

An FM aerial is required to receive VHF radio signals. An

external FM ribbon aerial is supplied as an accessory.

For optimal FM radio reception a roof or loft mounted aerial is

advised. For your own safety it is recommended that a roof top

aerial is ﬁ tted by an experienced contractor. Your Arcam dealer

should be able to put you in contact with an aerial installer.

A contractor will be able to tune your aerial to the nearest

FM transmitter. In an apartment building an aerial system may

already be installed. If this is the case you should have sockets in

your home marked FM or VHF (do not use those marked TV).

The ‘T’ shaped wire aerial (dipole design) supplied should give

reasonably good reception. Mount this aerial as high up as

possible on a wall with the elements positioned horizontally. Try

each usable wall of the room to see which gives best reception.

Use tacks or adhesive tape to secure the aerial in a T shape.

The tacks should not come into contact with the internal wire

of the aerial.

Whether you decide to get an aerial professionally installed or

opt to use the supplied aerial it should be connected to the FM

Antenna input

on the rear of the unit.

For use in North America, use an F-type antenna connector; for

Europe and other areas, use a female Belling Lee-type coaxial

connector.

T61 issue2.id 05/30/02, 7:43 PM4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam DiVA T61 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info