Bedienungsanleitung Arcam Neo (Seite 7 von 88) (Deutsch, Englisch, Holländisch, Französisch)

578807

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

English

VHF/FM

DAB

Solo Neo is tted with a DAB+/FM receiver module.

A roof-mounted aerial should be used wherever

possible to obtain the best reception.

Your Solo Neo is capable of superb FM and DAB/

DAB+ radio reception, but only if it is receiving a good

quality transmission signal.

DAB/DAB+ (Digital Radio)

If the transmission signal is strong in your area then

the supplied indoor aerial may be sucient (it should

be hung on a wall with both wires fully stretched out

vertically). In weak signal areas, an external aerial is

desirable in order to receive the highest number of

services.

DAB transmissions can be in either ‘Band III’ or the

‘L-band’ (or both). To determine the transmission

frequency in your area, contact your dealer, or refer

to www.WorldDAB.org. In Band III transmission areas,

use a multi-element Yagi aerial if you are a long

way from a transmitter, or use an omnidirectional

or folded dipole aerial if you are close to more than

one transmitter (in the U.K., a Band III region, this

should be mounted with the elements vertically, as

the transmissions are vertically polarised). If the DAB

services in your area are transmitted on L-band then

consult your dealer with regard to the best aerial to

use.

Whether you decide to install an external aerial, or

opt to use the supplied ribbon cable, it should be

connected to the F-type (screw) connector labelled

‘DAB+/FM’ on the rear of the unit.

The type of aerial you should use depends

on your listening preferences and the local

conditions. If you listen exclusively to FM

transmissions, for example, and the FM signal

strength is strong in your area, then a simple

omni-directional aerial mounted in your loft or

on your roof may be sucient. Listening to DAB

in a weak signal area will require a high-gain,

roof-mounted aerial.

For the best reception of both DAB and FM

signals, an aerial combiner box may be required

(as shown in the diagram opposite). This

combines the signals received by two aerials

(one for DAB, the other for FM), into one cable

that then connects to Solo Neo. If an aerial

combiner is not used, the single aerial chosen

for both DAB and FM reception may not give

optimum performance in some regions.

For the best advice, we recommend that you

contact your local Arcam dealer or aerial

installation expert.

FM Radio

Although an FM ribbon aerial is supplied as an

accessory to Solo Neo, for optimal FM radio reception

a roof- or loft-mounted aerial is advised as this will

give superior reception. In some areas cable radio may

be available or, in an apartment building, a distributed

aerial system may be installed. In either of these cases

you should have sockets in your home marked FM or

VHF (do not use those marked TV), which should be

connected to the connector labelled ‘FM’ on the rear

of Solo Neo.

If you wish to use the supplied FM ribbon cable,

mount this as high up as possible on a wall with the

‘T’-elements positioned horizontally. Try each usable

wall of the room to see which gives best reception

and use tacks or adhesive tape to secure the aerial in

a T shape, but note that no tacks should come into

contact with the internal wire of the aerial.

If you wish to receive both DAB and FM signals,

experiment with the orientation of the aerial for best

results.

aerial combiner

Wi-Fi Antenna

If you wish to use wireless networking (Wi-Fi) to

connect to your local network, the Wi-Fi antenna

must be installed.

Locate the ‘WiFi’ socket on the rear panel. Remove

the red protective cap (if installed) and screw on the

supplied aerial as shown.

An equipment cabinet can block the wireless signal.

The wired network connection is recommended for

enclosed installations.

Wireless networking requires network settings to

be entered into the Solo Neo. See pages 18—19 for

network conguration instructions.

DIGITAL

OUT

AV IN

SERIAL NO .

GAME TVTAPE OUT iPodZONE 2 PRE OUT

230V

50 – 60HZ

400V A

MAX

PROGRAM

SPEAKER

OUTPUT

12V

REMOTE

INOUT IN

TRIGGER

LOCAL

ZONE 2

ETHERNET

rDock / RS232

USB

DAB+

/FM

WiF i

Network

The Solo Neo can receive Internet

radio or stream music from

networked computers and hard

drives. Connect your router’s LAN

port to the ETHERNET socket using

Cat5 cable. See pages 18—19 for

network conguration instructions

if the network requires any

particular settings.

DAB+/ FM

Connect your DAB or FM aerial or

antenna cable to this F-type socket.

USB

Insert USB memory

devices here.

Radio aerial, Internet radio and computer network connections

Solo Neo also has USB, wired and wireless network

connections. The USB socket allows for the connection

of USB ash memory devices and MP3 players. The

network connection, whether wired or wireless, allows

for the reception of Internet radio stations and the

playback of music stored on your network.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Arcam Neo Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info