Bedienungsanleitung Argo Charm Plus (Seite 15 von 30) (Englisch)

805093

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

46V 11/22

Clean the air lter

Use a vacuum cleaner or water to rinse the lter, and if the lter is very dirty (for

example, with greasy dirt), clean it with warm water (below 45 °C) with mild

detergent, and then put the lter in the shade to dry in the air.

Mount the air lter

Reinstall the dried lter in reverse order of removal, then

cover and lock the panel.

CHECK BEFORE USING

1. Check whether all the air inlets and outlets of the units are unblocked.

2. Check whether there is blocking in the water outlet of the drain pipe, and immediately clean it up if any.

3. Check the ground wire is reliably grounded.

4. Check whether the remote control batteries are installed, and whether the power is sufcient.

5. Check whether there is damage in the mounting bracket of the outdoor unit, and if any, please contact our local

service center.

MAINTENANCE AFTER USING

1. Cut off the power source of the air conditioner, turn off the main power switch and remove the batteries from the

remote controller.

2. Clean the lter and the unit body.

3. Remove the dust and debris from the outdoor unit.

4. Check whether there is damage in the mounting bracket of the outdoor unit, and if any, please contact our local

service center.

Do not repair the air conditioner by yourself as wrong maintenance may cause electric shock or re or explode, please

contact the authorized service center and let the professionals conduct the maintenance, and checking the following

items prior to contacting for maintenance can save your time and money.

TROUBLESHOOTING

WARNING

Phenomenon Causes Troubleshooting

The air conditioner does not work

• There might be power outages.

• Power plug may be loose out from the

socket.

• Power switch fuse may blow.

• The time for timing boot is yet to come.

• Wait until power is restored.

• The plug in the plug tightly.

• Replace the fuse.

• Wait or cancel the timer settings.

Il climatizzatore non si avvia dopo averlo

arrestato • Il climatizzatore non riparte immediatamente

a causa del dispositivo di protezione

• Attendere almeno 5 minuti e riprovare.

The air conditioner stops running after it starts

up for a while

• May have reached the setting temperature.

• May be at a defrosting state.

• Shutdown Timer may be set.

• It is a normal function phenomenon.

• It will automatically restore and run again

after defrosting.

• If you continue to use, please turn it on

again.

The wind blows out, but the cooling/heating

effect is not good

• Excessive accumulation of dust on lter,

blocking at air inlet and outlet, and the

excessively small angle of the louver blades

all will affect the cooling and heating effect.

• Poor cooling and heating effect caused by

doors and windows opening, and unclosed

exhaust fan.

• Mode setting is incorrect, and the

temperature and wind speed settings are

not appropriate.

• Please clean the lter, remove the obstacles

at the air inlet and outlet and regulate the

angle of the louver blades.

• Please close the doors, windows, the

exhaust fan, etc.

• Please re-select the mode, and set the

appropriate temperature and wind speed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Charm Plus Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Charm Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info