Bedienungsanleitung Argo Khors (Seite 17 von 23) (Englisch)

805028

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

V 11/21 40

TIMER BUTTON (on both the remote control and portable unit)

Press this button for 1 second to set the timer.

1） Timer-on (automatic switch on)

When the appliance is off, set the time after which you want to turn on the unit. Press the + or - buttons to set the ignition

interval (each press corresponds to 0.5 hours) up to 10 hours. Over 10 hours by pressing the + or - button, each press

corresponds to 1 hour. Press the Timer button to confirm. When the Timer setting is finished, after 5 seconds without

further selections, the display returns to showing the temperature. The Timer Led on the control panel remains illuminated

during the selected time interval.

Remote control: Press the TIMER button. The T-ON and H icons will light up on the remote control. Within 5 seconds,

press the + and - buttons to set the operating time (to scroll the set time more quickly, keep the + and - buttons pressed at

the same time). Press the Timer button again to confirm the set time. The T-ON icon remains on and indicates that the

ignition TIMER is set.

2）Timer-off (automatic switch-off)

When the appliance is turned on, set the time after which you want to turn off the unit. Press the + or - buttons to set the

ignition interval (each press corresponds to 0.5 hours) up to 10 hours. Over 10 hours by pressing the + or - button, each

press corresponds to 1 hour. Press the Timer button to confirm. When the timer setting is finished, after 5 seconds without

further selections, the display returns to showing the temperature. The Timer Led on the control panel remains illuminated

during the selected time interval.

Remote control: Press the TIMER button. The T-OFF and H icons will light up. Within 5 seconds, press the + and - buttons

to set the operating time. Press the TIMER button to confirm the setting. The T-OFF icon remains on and indicates that the

shutdown TIMER is on.

Canceling the timer: If TIMER is set, press TIMER to view the set timer. Press TIMER again to cancel the set TIMER.

To speed up the time selection interval, hold down the + or - buttons for two seconds

X-FAN BUTTON (only on remote control)

In cooling and dehumidification mode it is possible to activate the X-FAN function.

After pressing the X-FAN button on the remote control, with the unit off, the unit's internal fan continues to operate for a

short time at minimum speed, to allow any residual water in the air pipe to dry. If you want to stop this function, press the

X-FAN button on the remote control again

TEMPERATURE AND ERROR DISPLAY

With the exception of message H8, tank full, when an error occurs do not try to repair the air conditioner, always take it to

an Argoclima Service Center, otherwise the guarantee will no longer be valid.

Problem Cause Solution

H8 Tank full of water. Empty the tank.

If the problem persists, contact a service centre.

F1, F2, F4, F0 Contact a service centre.

H3, E8

The room temperature exceeds the appliance's operating

range (beyond 35°) or there is too much humidity. Wait for

the temperature to drop below 35 °C.

Check if the evaporator and compressor are obstructed by

objects. If they are, remove the objects, disconnect the unit

then restore the power supply.

Clear the obstructed ventilation grilles.

If the problem persists, contact a service centre.

The temperature and error display lights up only in the COOL mode. In the DRY and FAN modes the display does not light

up.

SAFETY FUNCTIONS

REMOTE CONTROL LOCK

Simultaneously press "+" and "-" to lock the remote control.

The "Lock" icon will light up on the remote control, and the latter will not respond to commands.

SWITCHING BETWEEN °C AND °F.

Press the "-" and "MODE" buttons simultaneously to switch between °C and °F.

LIGHT FUNCTION

Press the “+” and “FAN” buttons simultaneously for 3 seconds to set the activation/ deactivation of the lamp.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Argo Khors Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Argo Khors

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info