7
EG
2
1
4
3
A) HOW TO SET THE ON TIME
1. Press the SEL TYPE button once.
The ON and time indications flash.
2. Press the SET H button until the desi-
gned hour is displayed.
Press the SET M button until the desi-
gned minutes are displayed. The display
will change automatically back to show
the present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the TIMER SEL button to activate
the ON timer.
B) HOW TO SET THE OFF TIME
1. Press the SEL TYPE button twice.
The OFF and time indications flash.
2. Press the SET H button until the desi-
gned hour is displayed.
Press the SET M button until the desi-
gned minutes are displayed. The display
will change automatically back to show
the present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the TIMER SEL button two times
to activate the OFF timer.
C) HOW TO SET A PROGRAM FOR DAILY
ON/OFF OPERATION (OR VICEVERSA)
1. Set the timer ON/OFF as shown in A)
and B).
2. Press the ON/OFF button to start the air
conditioner.
3. Press three times the TIMER SELECT
button to activate the DAILY timer.
SETTING THE TIMER
After timer setting, press PROGRAM button in order to check
the ON/OFF setting time.
When you set the timer, no signaling lamp appears on the unit;
please, refer to the remote control unit.
NOTES
SETTING THE 1 HOUR TIMER
This function causes the unit to operate for one hour at the set
conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
• Press four times the TIMER SEL
button.The 1 HOUR TIMER mark will
appear on the display.
CANCELLATION PROCEDURE
• Press the ON/OFF button to turn the air
conditioner off.
• Wait for the indoor unit to stop operating.
• Press the ON/OFF button again to turn the
air conditioner on.
For continuous drainage: Switch off the unit and remove the main plug from the supply. Remove the rubber plug from the drain
pipe at the bottom rear of the air conditioner and connect a drain tube (20 mm inmer diameter) on to the drain pipe: Place the other
end in a normal drain.
Make sure that the tube is free from twists and bends. The tube must decline over its entire lenght.
Emptying the internal water container: Occasionally it is necessary to empty the internal water container. When the internal
water container is full the STANDBY lamp blinks.
Every time you move the unit to another room or when you store it, discharge the condensate water container, through the drain
pipe.
To empty the water container do the following action: put a container under the drain pipe at the bottom rear of the unit, remove the
rubber plug and allow the water container to drain. Replace the rubber plug onto the drain pipe and continue to use the air conditio-
ner.
DRAINING
