Bedienungsanleitung Ariston AB1030C (Seite 11 von 15) (Englisch)

47629

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Fig. 1

Fig. 2

Removing limescale

Water contains increasing amounts of limescale because of

pollution. If you live in a hard water area in addition to

using water-softener in each wash, it is a good idea to put

the machine through a cycle without laundry or detergent,

just using limescale remover.

Trouble shooting

If the machine does not seem to be working properly before

calling the service engineer there are a number of things

you can check. Perhaps you have forgotten to push in a

button or you are not using the machine properly.

Machine won't start

Make sure:

the appliance is plugged to the mains socket; you have

electricity in your home, the door is firmly shut, the ON/OFF

button F is on I, the programming cycle knob, in washer-

dryers which have one, is on O, the programme is properly

set and the mains water tap is open.

Machine won't fill

Make sure:

the water tap is open and connected correctly to the hose;

the water mains has not been cut off and that water pressure

is sufficient; also check the hose for kinks.

Water is pumping in and out all the time

Make sure:

there are no kinks in the drain pipe and that it is at least at a

height of 60-100 cm; the pipe mouth is not below water

level and that the wall drain has no air outlet. If the problems

continue even after you have checked these points, shut

the water tap and turn off your washer-dryer.

Problems with pumping out water or

spinning

Make sure:

the programme selected has a draining cycle; the non

creasing "hydropstop" button, on washer-dryers which have

one, has not been pressed accidentally; the drainage pump

is not jammed; the drain pipe is bent; the drainage piping is

plugged; any drainage pipe extensions are properly

connected and do not prevent water flow.

The washer-dryer is not drying

Make sure:

the plug is inserted properly into the socket; there is electricity

in the house; the washer-dryer door is closed; the ON-OFF

button F is on the I setting; the programming cycle knob, in

washer-dryers which have one, is on the O setting; the

program knob A is on the setting; the dryer knob B is on

the O setting.

Lots of vibration during the spin

Make sure:

the internal oscillating unit was released correctly at the time

of installation (see installation instructions); the washer is

levelled correctly or too tightly fitted between furniture units

and the wall.

Your washer is leaking.

Make sure:

the ring nut of the supply pipe is firmly tightened; the

detergent dispenser is not plugged and the drainage pipe is

firmly fixed.

Excessive formation of suds.

Make sure:

the type of detergent you have used - is it suitable for an

automati washer - have you used too much detergent?

The washer-dryer is not drying efficiently.

Make sure:

the end of the drain hose is not immersed in water; the

drain pump is not blocked (see "General maintenance");

the advice on maximum loads and drying times have been

followed; the drying time selected is at least 20 minutes; the

water tap is turned on.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ariston AB1030C Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info