Your XENA is equipped with a data base containing the parameters of all the satellites preset. It can happen,
however, that these parameters change. In this case, if the satellite can not be located, it is necessary to update them,
by entering the frequency, the polarisation and the symbol rate of a bouquet carried by the satellite concerned.
In the automatic mode, the satellite search phase is preceded by a phase during which the motor is initialised : the
satellite position is then set on the basis of a 0 position. In the semi-automatic mode, the satellite position is
calculated on the basis of the current position : this is why you should use the semi-automatic mode (quicker than the
automatic mode) only when you have saved at least one correct satellite position. When first using your equipment,
just after pointng the reference satellite, it is necessary to RECALCULATE THE SATELLITE POSITIONS. This
operation enables the motor to memorise the position of all the other satellites with respect to the reference pointing
direction you have just set.
♦ Press SAVE to enter your configuration.
If, in addition, you use a fixed dish on input B, programme this as indicated in a).
c) COMMUNITY INSTALLATIONS IN MODE ISB
♦ In the TYPE OF INSTALLATION menu, select COMMUNITY FI/FI
♦ Use keys 3 and 4, according to whether your appliance requires LBN power supply or not.
♦ Press OK to enter the different search rates (then use 5,6,3,4 then the numerical keypad and press OK)
♦ Press SAVE to enter your settings
The search will be carried out for all the search rates declared active.
5.5 AUTOMATIC CHANNEL SEARCH
a) FOR FIXED DISH INSTALLATIONS
♦ In the INSTALLATION menu, select AUTOMATIC SEARCH
SCREEN E22
♦ To carry out a complete search on all the satellites, select the option ON ALL SATELLITES (use keys
5 and 6, the press OK to enter).
During a complete search on all the satellites, the former programme base will be deleted and replaced by the new
one.
♦ The installation will commence immediately after you have pressed the OK button again.
♦ When this is finished, save your new programme base, by pressing the SAVE button.
♦ If you wish to install one of the active satellites, select “ON ONE SATELLITE”. Select the dish
pointed towards the satellite to be installed, the name of the satellite then the type of search
(ANALOGUE AND/OR DIGITAL), then press OK. The search will commence immediately after you
have pressed OK again. When it is finished, press SAVE to save your new programme base.
If the satellite had already been installed previously, the programme base will be automatically
updated on this satellite, whereas the channels of the other satellites of the installation will be
preserved. You can interrupt the installation at any moment by pressing the OK button, then
SAVE if you wish to save the channels selected, or R to quit without modifying the initial list.
