Bedienungsanleitung Astralpool Viron eVo (Seite 14 von 20) (Englisch)

673158

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Inst.296 Viron eVo Series Pool & Spa Heater V07_16

CONDENSATE DRAIN

The Viron heater is a highly efficient gas appliance capable of generating up to 12 litres an hour of condensation.

Suitable drainage provision must be provided to ensure condensation does not build up in the heater or flood

damage surrounding areas. Do not raise the drain hose higher than the exit point of the appliance.

Alternatively, the condensate can be used to replenish or “top up” your pool water. A condensate recovery kit can

be purchased from your local Astral Pool equipment supplier.

The condensate has a pH of approximately 6.8. Most chlorines and sanitisers used for pool water disinfection will

increase the pool water pH over a period of time, so an additional advantage of the condensate produced by your

Viron Heater is that the low pH will counter balance the high pH of the disinfectant used in most pools.

IMPORTANT: Chlorines, disinfectants and sanitisers usually require a narrow bank of pH in which to work

effectively. Ensure you check the pH of your pool or spa weekly, and adjust as necessary.

ELECTRONIC FLOW RESPONSE

The Viron eVo heater is capable of being linked to the AstralPool series of Viron multispeed pumps via RJ12

cabling (not supplied). By taking advantage of this connection, you can ensure your heater will operate at peak

performance and last for many years.

Connection to the Viron heater is via the RJ12 socket located inside the access panel where the water connections

are made to the heater. Connections for the pump are made through the rear of the electrical box.

In connecting your Viron Pool and Spa heater to your Viron multispeed pump, the two appliances will communicate

to adjust speeds on the pump based on the demands of the heater.



If the heater is in the ON position pump will operate at a minimum of “Medium” speed



If the heater is operating (burner symbol on screen) the pump will operate on “High” speed



When the heater shuts off the pump will return to the default speed set on the pump

If you require assistance with this connection, please contact your local AstralPool Australia branch for further

advice.

TROUBLESHOOTING

HEATER WILL NOT LIGHT

Possible cause

Remedy

No display

Check if power to heater is turned on

Pump not running

Start pump

Pump air locked

Check for leaks

Filter dirty

Clean filter

Pump strainer basket clogged

Clean strainer

Thermostat turned off

Turn on

Set temperature lower than water temperature

Increase set temperature

Water too hot-fault condition displayed

Refer to fault indication table

Gas turned off

Turn gas cock on

Heater in a Fault condition

Refer to fault indication table

HEATER SHORT CYCLING (RAPID ON AND OFF OPERATION)

Possible cause

Remedy

Insufficient water flow

Clean filter and pump strainer

HEATER MAKING KNOCKING NOISES

Possible cause

Remedy

Low water flow

Check pump condition

Heater operating after pump has shut off

Shut off gas supply and call for service

Heat exchanger scaled

Shut off gas supply and call for service

If the heater cannot be made to perform correctly, please contact the Astral Pool office closest to you.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Astralpool Viron eVo Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info