Bedienungsanleitung Atlantic Steatite (Seite 9 von 24) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

613601

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

ENGLISH (EN)

WARNINGS: This device is not intended for use by persons (including children) with physical, sensory

or mental disability, or by persons lacking experience or knowledge, unless they have received from a

person in charge of their safety adequate supervision or preliminary instructions on how to use the

device. Children should be supervised to ensure that they do not play with the appliance. This unit can

be used by children of not less than 8 years and people with reduced physical, sensory or mental

capabilities or without experience or knowledge if they are properly supervised or if the instructions for

using the device safely have been given and if the risks are taking into account. Children must not play

with the device. Cleaning and maintenance must not be done by children without supervision.

1. CAUTION! Heavy item, handle with care:

1.1 Install the appliance in a room which is protected from frost. If the appliance is damaged because

the safety device has been blocked, it is not covered by guarantee,

1.2 Make sure that the wall on which the appliance is mounted can support the weight of the

appliance when filled with water,

1.3 If the appliance is to be fitted in a room or location where the ambient temperature is higher than

35°C, provide sufficient ventilation,

1.4 When installed in a bathroom, do not install the appliance in volumes V0 and V1 (See fig.

p.3). If the water heater is to install above living space, fit a retaining tank with drain to the sewer

system. Place the water heater in a place with easy access,

1.5 If PER pipes are used, the installation of a thermostatic regulator on the output pipe of the device

is strongly recommended. It will be set according to the performance of the material used.

1.6 Installation of a vertical or horizontal wall mounted device: To allow the replacement of the

heating element leave a free space of 300mm between the tube ends and the wall or fixed

furniture.

1.7 Switch off the power before removing the cover, to avoid any risk of injury or electric shock.

1.8 The installation must be equipped, upstream of the appliance, with a bipolar cut-out device (fuse,

breaker switch) respecting local regulations (30 mA earth-leakage breaker).

1.9 If the supply cord is damaged, it must be replaced by a special cord or assembly available from

the manufacturer or the after sales service.

1.10 Mandatory installation of a safety device in a frost free location (or any other new device which

limits the tank pressure) to 7 or 9 bar (0.7 or 0.9 MPa) according to the nominal pressure, with a

size of ½ "or ¾" on the input of the water heater, respecting the local regulations (see table p.1),

1.11 Operate regularly the discharge of safety device to prevent scaling and check that it is not

blocked.

1.12 Hydraulic accessories should not be located between the safety valve and the cold water inlet. A

pressure reducer (not supplied) is required when the water supply pressure exceeds 5 bar (0,5

MPa) and will be fitted on the main supply.

1.13 Connect the safety device to an unpressurised outlet pipe in a frost free location, with a

continuous slope to evacuate water during heating up or draining the water heater.

1.14 The pipes used must support 10 bars (1 MPa) and 100 ° C.

1.15 To drain the device: Switch off the power and the supply of cold water, open the hot water

faucets and manipulate the safety valve. To drain under sink water heater disconnect the

hydraulic connections and return the device.

1.16 The products described in this manual are subject to changes at any time to be in

accordance with technology and standards. The devices comply with electromagnetic

directives 2004/108/EC and Low Voltage 2006/95/EC.

1.17 Do not dispose your water heater in the garbage, but hand it to a place assigned for this purpose

(collection point) where it can be recycled.

2. INSTALLATION

- Refer to the corresponding diagrams p.2 & 3 (see table on right):

- Make sure to keep free space of 300 mm below pipes for the exchange of

the heating element.

- For vertical installation of Ø 505 devices if the wall is not strong enough, an

optional ground support is available. Nevertheless, it is mandatory to fix the

unit to the wall with the top bracket to avoid tipping.

- For horizontal installation, the water connection tubes must always be in a

vertical position below the device.

3. HYDRAULIC CONNECTION

- It is necessary to clean the supply piping prior to the hydraulic connection. The connection to the hot water outlet is to be

carried out with a cast iron or steel sleeve or a dielectric connector, to avoid corrosion of the pipe (direct contact iron /

copper). The use of brass fittings is prohibited.

Diameter

Vertical

installation

Horizontal

installation

Ø255

See fig. &

Ø338

See fig. &

See fig.

Ø433

See fig. &

See fig.

Ø505

See fig.

1.16

bili u skladu s tehnologijom i standardima. u s direktivom 2004/108/EC

te direktivom za niski napon 2006/95/EC.

1.17

1. INSTALIRANJE

- idjeti tablicu desno):

- Za vertikalnu

- Za horizontalnu instalaciju, cijevi za vodu uvijek moraju biti postavljene

ako bi se izbjegla korozija na cijevi (izravan kontakt

Upotreba mesinganih sponica je zabranjena.

2.1 INSTALACIJA POD TLAKOM : Vidjeti fig.

, & , p.3.

vode bojlera, koji je u skladu sa standrardima (EN 1487 u Europi), s tlakom od 7 ili 9 bari (0,7 ili 0,9 MPa), u skladu s

nominalnim tlakom, promjera 1/2" ili 3/4" (tablica p.1).

2.2 INSTALACIJA BEZ TLAKA: Pogledati fig.

- OPREZ

nemojte ga upotrebljavati.

- 

- Koristite

standardizirano kana

ili instalirati.

simbolom -

- Toplinski osig

A: Prekini dovod napona prije bilo kakve operacije B: Ukloni

C: Provjeri el D:

termostata.

4. POKRETANJE

- BOJLER BEZ VODE:

of the device, voda bi trebala kapati iz odvoda.

: Ukoliko

- OPREZ: Pr

A: Kamenac: Ukolnite

prvog grijanja . B:

promjer postane manji od 10mm. C:

nja, stegnite

ponovo ukoliko je potrebno. D:

Zamjenjivi Garancija

SAVJET KORISNIKU:

TH> 20 ° f ( >200 ppm ), preporuka je da se

pokretanje.

Promjer

Vertikalna

instalacija

Horizontal

instalacija

Ø255

See fig. &

Ø338

See fig. &

See fig.

Ø433

See fig. &

See fig.

Ø505

See fig.

Atlantic Steatite Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info