Bedienungsanleitung ATTACK DPX Combi Pellet (Seite 37 von 100) (Englisch)

810510

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

ler´s operating mode (reaching the flue gas temperature of [

90]). If the temperature of [

90] is

not reached during the heating up, the fan is stopped and the alarm FUEL (fuel shortage) is dis-

played.

[Fb30] Duration of boiler stop by flue shortage and burn–down – the fuel amount test is ac-

tivated in the operating mode, when the flue gas temperature decreases under the parameter [

90] or (if the flue gas sensor is not connected) when the boiler temperature decreases under the

adjusted parameter [L 45]. If the temperature does not exceed the necessary limit during this

period, the controller displays FUEL alarm.

[Ar 0] Operation of multifunction additional output – the controller is equipped with an addi-

tional multifunctional outputs compatible with the options listed below (to control these op-

tions is necessary to use an additional module UM – 1):

• [Ar 0] parameter – indicates start of the automatic boiler (e.g. gas or pellet boiler). When the

controller is started and the boiler generates heat, the automatic boiler is stopped. Operation

of the automatic boiler is blocked by the controller in the operating mode. The automatic

boiler is started by controller, when the fuel is burned down in the boiler and the FUEL alarm

is displayed.

• [Ar 1] parameter – indicates that the additional multifunctional output will be used for error

messages like boiler sensor failure, overheating or fuel shortage.

[

240] Adjusted flue gas temperature – the controller will struggle to reach and to keep this

value. The flue gas temperature sensor is turned off, if this parameter is set to „– –“.

[

h5] Hysteresis of flue gas temperature – defines the difference for which must the flue gas

temperature decrease to increase the fan rotations.

[

t 5] Time constant of stabilization the flue gas temperature – defines the period of adjust-

ing the fan rotations during stabilization of the flue gas temperature. If the flue gas temperature

exceeds the value given by the parameter [

240], the controller starts to decrease the fan rota-

tions gradually, until the flue gas temperature decreases to the adjusted value. If the flue gas

temperature decreases to the value of flue gas temperature hysteresis, the controller starts to

increase the fan rotations gradually.

[

F10] Blower speed jump while stabilizing exhaust gas temperature – defines the change

of rotations to achieve the adjusted flue gas temperature.

[

90] Flue gas temperature by fuel shortage – the message „FUEL“ for fuel shortage is dis-

played after the flue gas temperature decreases under this value.

Testing the regulator outputs:

It is possible to make a check to test the correct functionality of the regulator and devices con-

nected. The correct function of fan is tested by selecting the [outΠ] on display and holding the

„OK“ button. Test of the circuit pump is done by selecting the [outP]. Select the [outu] to start

the additional output and [outr] for multifunctional additional output.

Reset of the regulator´s pruduction settings:

There is a possibility to reset the production settings of the regulator by selecting the [Prod] in

the service menu and confirming by „OK“ button. Then is the regulator set to the values given in

the Table 3.

Exit from service menu:

Select the [End] on display and press the „OK“ button to exit from service menu.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATTACK DPX Combi Pellet Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info