Bedienungsanleitung ATTACK SLX (Seite 14 von 120) (Englisch)

810506

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

During the installation of the boiler must be ensured a safe distance of its surface from the

flammable materials depending on their flammability level:

• Materials of flammability level B, C1 a C2 200 mm

• Materials of flammability level C3 400 mm

• Level of flammability was not proved according to STN 73 0853 400 mm

Examples of building materials division according to the level of flammability:

• Level of flammability A not flammable (bricks, breez blocks, ceramic tile, mortar, plaster)

• Level of flammability B partly flammable (heraclit, lignos, board made out of basaltic felt, novodur)

• Level of flammability C1 hard flammable (broadleaf wood (beech, oak), plywood, werzali, hardened

paper)

• Level of flammability C2 intermediate flammable (coniferous wood (pine, spruce), chipboard, so-

lodur)

• Level of flammability C3 easily flammable (wood – fibre, polyurethan, PVC, soft foam, polystyrene)

The sealing board or protection covering (on the protected object) must exceed the boiler edge

at least for 300 mm. Also other items from flammable materials must be protected in this way, if

they are placed near the boiler and it is not possible to keep the safe distance.

If the boiler stands on the flammable surface, it must be protected by an inflammable, heat insu-

lating mat, which exceeds the ground plan on the side of the feeding door and ash tray door for

at least 100 mm. All materials of the flammability level A might be used as an inflammable, heat

insulating mat.

Boiler must be placed in a such way, ensuring sufficient space of at least 1 m from the front and

0,5 m from the left (right) and rear side. It is necessary to leave the space of at least 1 m above

the boiler.

This space is necessary for basic operation, maintenance and eventual service of the boiler. It is

not allowed to place the boiler in dwelling premises (including corridors).

WARNING: Items from flammable materials must not be laid on the boiler and in the

distance shorter than the permitted (safe) one. The boiler must be put out of operation,

if there is a danger of fire or explosion during the work (e.g. work with painting materi-

als, glues, etc.).

5.4 CONNECTION OF THE BOILER TO THE HEATING SYSTEM

Boiler ATTACK® SLX has to be installed in the system, which meets the requirements of the heat-

ing water quality as follows:

Country Number of standards Country Number of standards

Slovak republic STN 07 7401:1991 Switzerland SWKI 97 – 1

Austria ONORM H5195 – 1 Italy D.P.R. no. 412

Germany VDI 2035

For filling or refilling the water in the system might be used only water which is adapted for val-

ues according to STN 07 7401: 1992. Water has to be clear, colourless, without any suspended

substances, oils and chemical agressive additives and cannot be acidic (pH has to be higher than

7,2). Water hardness cannot exceed 1 mmol/l and concentration of Ca²Ѐ 0,3 mmol/l.

NOTICE: The warranty of the boiler is not valid in case of infringement of these conditions!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ATTACK SLX Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von ATTACK SLX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info