Bedienungsanleitung Audiolab 8000AP (Seite 12 von 24) (Englisch)

496152

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

7b: Setting Up the 8000AP - 2

• Press to

jump up to the

front page

• Press the

keys to select

• Press

Press the

keys to select

You will hear a burst of white noise from the Left Front speaker.

The volume at the Left Front speaker sets the reference level

for the calibration. All levels must be set to this reference.

Individual levels can be varied by up to +/- 10dB.

When the noise generator Is turned on, the volume

automatically goes to -30dB. This master level may be

adjusted to suit your system with the volume control on the

front panel or via the handset.

Set the meter to ‘C’ weighting

with ‘slow’ response and to read 75dB SPL at centre scale.

Place the meter at ear level at your listening position.

Point the microphone at the ceiling.

Adjust the Volume level so the sound level meter reads75dB.

Select each speaker in turn. Adjust the relative channel levels

on-screen using the keys on the handset until the sound

level meter reads 75dB on all channels.

Sit in your normal listening

position. With the Volume keys, set the Left Front speaker

to the equivalent to normal conversation. Now select each

speaker in turn and adjust the on-screen level using the

keys on the handset to sound the same as the Left Front

speaker. During this process you may have to re-visit some

loudspeakers to reset the level.

Leave the subwoofer level on the screen at 0dB. Adjust the

subwoofer’s volume control to sound as close to the reference

Left Front speaker as you can. Now trim the on-screen

subwoofer level with the keys on the handset. The object

is to get the subwoofer level as close to 0dB as possible.

BACK

Speaker Levels.

ENTER

•

Noise On

Setting up the Subwoofer input level:

įĬ

ǡǠ

įĬ

ǡǠ

Do not adjust the volume

during calibration after the level is established.

Using a Sound Level Meter:

seated

Set Up By Listening- seated

Do not adjust the volume control during the calibration.

Loudspeaker Distances

Speaker Calibration

• Press to jump back up to the front page

• Press the keys to select

• Press

These measurements are used by the 8000AP in surround

modes to correct for delays in sound reaching your ears due

to differences in the distance between each speaker and the

listening position.

Use the keys to select the loudspeaker and the keys

to vary the distance. The distance can be set from 0 to 10

metres in units of 25cm. A speaker entered as will have

no distance shown on the screen.

Speaker calibration is essential to achieve a correctly centred

soundimage;followitcarefully.Wesuggestyouuseasound

level (SPL) meter; otherwise you can set up the levels by ear- you

will have to be careful to match the output levels for each

speaker to sound equally loud.

BACK

“Speaker Distance”.

ENTER

none

įĬ

įĬ ǡ Ǡ

Page 10

• Press the

keys to select

• Press

: you will be

able to select or for the surrounds.

: you will be

able to select or for the surrounds.

• Press the

keys to select

• Press

By default the Back speakers are fixed at with

predetermined bass cut-off at 100 Hz. You can select

(for 6.1) or (for 7.1).

• Press the

keys to select

• Press

• Select

įĬ

“Surround”.

ENTER

If you have set the front speakers to Large

Large, Small None

If you have set the front speakers to Small

Small None

After setting up the size and bass parameters of the

surround speakers:

“Back”

ENTER

Small

None,

One , Two

After setting up the size and bass parameters of the

back speakers:

“Subwoofer”

ENTER

Yes/ No

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Audiolab 8000AP Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info