Bedienungsanleitung Austria Email EKF series (Seite 26 von 36) (Deutsch, Englisch)

800546

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Id.Nr.: 123158-19

Drinking water of appropriate quality is necessary for correct operation.

We recommend the installation of an upstream water lter to avoid any possible inltration. Furthermore, a

minimum conductivity of ≥ 150 S/cm must be available in order to ensure adequate corrosion protection.

To avoid damage, it is necessary to construct the connection of the storage tank with a detachable

connection (union).

Leaks from the storage tank as a result of an improper connection and damage and consequential dama-

ge caused by this are excluded from the guarantee and product liability.

Should a device, at the point of delivery, clearly display a malfunction, damage or other defect, this must

not be tted, installed or used in the system. Subsequent complaints regarding devices with an obvious

defect which have been connected and installed are expressly excluded under the warranty and guaran-

tee.

INSTALLATION AND SAFETY INSTRUCTION

a) The electric at storage tanks may only be mounted vertically (plumb).

b) The device dimensioned drawings and all notices provided with the device must be observed during

installation.

c) Warning: The combined weight of the hot water heater and the weight of the water contents (nominal

capacity) must be considered when calculating the loading and rigidity requirements for the mounting

surface and/or mounting location. Special mounting: See thin-wall mounting

d) If a hot water heater is equipped with ancillary structures (cladding) or installed in conned spaces

or intermediate ceilings, then it is essential to ensure that the connection side of the device remains

accessible (water connections, electrical connection space and heater installation) and that heat ac-

cumulation does not occur. A clearance of 500 mm at the lower right of the device must be provided

for extension of the heating ange. A clearance of at least 50 mm above the tank must be provided to

allow hanging.

e) The tank is hung on the wall rail provided, which is attached to the wall using two screws. The screw

heads/bolts must not protrude more than 15 mm out of the wall. When hanging the device, make sure

that the bracket on the rear of the device latches securely into place. The lower wall bracket has no

supporting function and may therefore not be subject to any excessive stress. Caution: Only xing

hooks provided by the manufacturer may be used!

If the assembly height is changed, this is to be tightened to the mounting screws with a torque of 40 -

50 Nm.

f) When selecting the installation materials and their sequence of installation (caution

is required for mixed installations), care must be taken according to the currently applicable rules of

technology to ensure no detrimental electrochemical eects (e.g. copper-steel contact corrosion). We

recommend the installation of insulated screw connections.

g) In the case of especially aggressive water requiring special installation solutions, the possible necessity

for a special version of the tank should also be checked (ask our representatives or ask us directly).

h) The device is equipped with a safety temperature limiter which turns o further heating of the appliance

at a temperature of max. 110 °C (EN 60335-2-21; OVE-EW41, Part 2 (500) /1971). Therefore, select

connection components (pipe ttings, safety valve combination, etc.) that can resist temperatures of

110 °C in the event of any possible malfunction of the thermostat and thus preventing consequential

damage.

i) Assembly and installation may be performed only by authorized specialists.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Austria Email EKF series Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info