661200
131
Zoom out
Zoom in
Vorherige Seite
1/140
Nächste Seite
Troubleshooting
Appendix A-15
MAINTENANCE AND TROUBLESHOOTING
A
Fabric puckers.
There is a mistake in the upper or bobbin
threading.
Check the steps for threading the machine and
rethread it correctly.
B-19
Spool cap is set incorrectly.
Check the method for attaching the spool cap,
then reattach the spool cap.
B-19
Using improper needle or thread for the
selected fabric.
Check the “Fabric/Thread/Needle Combination”
chart.
B-26
Needle is turned, bent or the point is dull. Replace the needle. B-27
Stitches are too long when sewing thin fabrics. Shorten the stitch length. B-37
Thread tension is set incorrectly. Adjust the thread tension. B-38
Wrong presser foot. Use the correct presser foot. B-30
Skipped stitches
Machine is threaded incorrectly.
Check the steps for threading the machine and
rethread it correctly.
B-19
Using improper needle or thread for the
selected fabric.
Check the “Fabric/Thread/Needle Combination”
chart.
B-26
Needle is turned, bent or the point is dull. Replace the needle. B-27
Needle is installed incorrectly. Reinstall the needle correctly. B-27
The needle is worn/damaged. Replace the needle. B-27
Dust or lint has collected under the needle
plate.
Remove the dust or lint with the brush. A-2
Thin or stretch fabrics are being sewn.
Sew with one sheet of thin paper under the
fabric.
S-4, D-3
No stitching
Needle is turned, bent or the point is dull. Replace the needle. B-27
Bobbin is set incorrectly. Reset the bobbin thread correctly. B-16
Upper threading is incorrect.
Check the steps for threading the machine and
rethread the machine.
B-19
High-pitched
sound while
sewing
Dust or lint is caught in the feed dogs. Remove the dust or lint. A-2
Pieces of thread are caught in the race. Clean the race. A-2
Upper threading is incorrect.
Check the steps for threading the machine and
rethread the machine.
B-19
A bobbin designed specifically for this machine
is not used.
Incorrect bobbins will not work properly. Only
use a bobbin designed specifically for this
machine.
B-13
There are needle holes or friction scratches in
the bobbin case.
Replace the bobbin case, or consult your
authorized Baby Lock retailer.
A-2
Fabric does not
feed through the
machine.
Feed dogs are set in the down position.
Slide the feed dog position switch to the right
.
B-2
Stitches are too close together. Lengthen the stitch length setting. B-37
Wrong presser foot was used. Use the correct presser foot. B-30
Needle is turned, bent or the point is dull. Replace the needle. B-27
Thread is entangled.
Cut the entangled thread and remove it from the
race.
A-7
Zigzag foot “J” is slanted on a thick seam at the
beginning of stitching.
Use the presser foot locking pin (black button
on the left side) on zigzag foot “J” to keep the
presser foot level while sewing.
S-4
Presser foot pressure is set incorrectly for
fabric.
Adjust the presser foot pressure
within the settings screen.
B-41
Symptom Probable Cause Remedy Reference
131

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Baby Lock Katherine - BL210A wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Baby Lock Katherine - BL210A

Baby Lock Katherine - BL210A Kurzanleitung - Englisch - 4 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info