Bedienungsanleitung Barbecook Impuls 3.0 (Seite 34 von 56) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch)

503184

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

34 www.barbecook.com

Ensurethat:

• Thebarbecueiscorrectlyinstalled

• Thereisnoleakinthegassupply

(see ‘Leakage test’)

• Theburnersarecorrectlyinstalled,

the venturi tubes are properly placed

over the openings of the gas valves

(Fig. D), and there are no obstruc-

tions (see safety information and

cleaning of the burners)

• Noneofthegassupplyhosescan

come into contact with a hot surface

• Yourbarbecueisinstalledinasafe

place

LIGHTING THE BURNERS

Prior to lighting the burners, all checks and

procedures detailed in the chapter ‘Before

the first use’ must have been carried out.

• Thelidofthebarbecuemustalways

be open when you light the burner(s)

• Donotbenddirectlyoverthebarbe

cue when lighting the burner(s)

• Thecontrolknobsofthebarbecue

must be ‘OFF’. Slowly open the gas

cylinder valve. Before opening the

control knob of one burner, wait ap-

prox.10secondstoallowtogasto

stabilize

• Important:firstlightthemiddle

burner

• Assoonasoneburnerhasbeen

lighted, you only need to put the

control knob of the other burner(s) in

the position ‘HIGH’ to light them.

• Nevertrytolightallburnersatonce

HIGH

LOW

LIGHTING THE BURNERS WITH THE

IGNITER

• Holddownoneofthelargebut

tons and turn to HIGH. You will

hear the piezoelectric igniter click

as it sparks. The spark will light the

burner.

• Presstheigniteruntilyouhear

sparks

• Holdingdowntheigniter,pressthe

control knob of the middle burner

and turn to ‘HIGH’

• Iftheburnerdoesnotlightafter3

attempts, disconnect the gas and

wait5minutesbeforetryingagain.

This will allow the accumulated gas

to escape. Try again, repeating the

above steps.

• Iftheburnerstilldoesnotlight,read

the chapter ‘Troubleshooting Guide’

to determine the cause and the rem-

edy, or use a match as described

below.

LIGHTING THE BURNERS WITH A

MATCH

Left and right at the bottom of the burner

box is a small opening that can be used to

light the burners with a match, if the elec

tronic igniter does not work. (Fig. G)

• Openthelidofthebarbecue

• Placeamatchinthematchholder

provided (Fig. G)

• Holdaburningmatchthroughthe

hole, approx. 13 mm from the burner

• Openthegascylindervalve.

• Pushtherequiredcontrolknoband

turn to ‘HIGH’. The burner should

lightwithin5seconds.Ifnot,turn

thecontrolknoboffandwait5min-

utes to allow the gas to escape.

• Repeatsteps1through5.Ifthe

burner still does not light after 3

attempts, read the chapter ‘Trouble-

shooting Guide’

LIGHTING THE OTHER BURNERS

• Assoonasthefirstburnerhasbeen

lighted, you only need to put the

control knob of the other burner(s) in

the position ‘HIGH’ to light them.

LIGHTING THE SIDE BURNER USING

THE IGNITER

First open the lid of the side burner.

To light the side burner, use the igniter on

the control panel and the control knob on

the side table.

• Holddowntheleftmost(small)but

ton and turn to HIGH. You will hear

the piezoelectric igniter click as it

sparks. The spark will light the side

burner.

• Repeatanumberoftimesifthe

burner does not light immediately.

• Iftheburnerdoesnotlightafter

5seconds,turnthecontrolknobto

‘OFF’andwait5minutestoallow

the gas to escape.

• Repeatsteps1through3.Ifthe

burner still does not light, read the

chapter ‘Troubleshooting Guide’ or

use a match as described below.

Note:

• themaximumloadoftheside

burner is 9 kg!

• themaximumdiameterofthecook-

ingvesselis220mm

LIGHTING THE SIDE BURNER WITH A

MATCH

• Placeamatchinthematchholder

provided

• Holdaburningmatchapprox.

13 mm from the burner (Fig. H)

• Pushthecontrolknoboftheside

burner and turn to ‘HIGH’. The burn-

ershouldlightwithin5seconds.If

not, turn the control knob ‘OFF’ and

wait5minutestoallowthegasto

escape.

• Repeatsteps1through3.Ifthe

burner still does not light, read the

chapter ‘Troubleshooting Guide’ to

determine the cause and the rem

edy.

VISUAL CHECK OF THE FLAMES

If the flames of the burners jump out of the

burner box when the barbecue is in use,

immediately turn off the control knobs.

Wait5minutestoallowthegastoescape

before relighting the barbecue. Read the

chapter ‘Troubleshooting Guide’ if the

problem persists.

Each time you light the barbecue you

should check the flames. (Fig. I) A proper

flame is almost comletely blue, with some

yellow at the top. If the flame is abnormally

small and for the most part yellow, switch

off the barbecue and check the venturi

tubes for obstructions, or read the chapter

‘Troubleshooting Guide’.

Man_Impuls_3.0_4.0_DE_A_121024.indd 34 30/10/12 10:06

Barbecook Impuls 3.0 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info