Bedienungsanleitung Bauknecht BIK7 CSP8TS PT (Seite 7 von 15) (Englisch)

723440

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Turn the selection knob on to show “Cleaning” on the

display.

Turn the adjustment knob to select the desired cycle,

then press

to confirm.

Pyro

The display will prompt you to do all actions needed

to obtain the best cleaning results.

Once a cycle has been selected, if desired, turn the

adjustment knob to set end time (start delay), then

press

to confirm.

Once you have done all steps, when required press

to activate the cleaning cycle.

The oven will begin the self-cleaning cycle, while the

door locks automatically: a warning message appears

on the display, along with a countdown indicating

the status of the cycle in progress.

Once the cycle has been completed, the door remains

locked until the temperature inside the oven has

returned to a safe level.

• DRAIN

The drain function allows the water to be drained in

order to prevent stagnation in the tank. It is advisable to

always carry out draining every time the oven has been

used.

Anyway, after a certain number of cooking this action

will be mandatory and it will not possible start a steam

function before done it.

Once selected the “Drain” function or

when suggested from display, press

and follow the actions indicated:

Open the door and place a large jug

under the drain nozzle located at the

bottom right of the panel. Once

started the draining, keep the jug in

position until the operation is completed.

The display will indicate when the tank has to be

completely drained.

Please note: it is not possible to perform this activity before 4

hours have elapsed from the last cycle (or the last time the

product was powered). During this wait time, the display will

show the following feedback “WATER IS HOT - PLEASE WAIT”.

The jug must be at least 2 liters large.

• DESCALE

This special function, activated at regular intervals,

allows you to keep the boiler and the steam circuit in

the best condition.

The function is divided into several phases: draining,

descaling, rinsing. Once the function is started, follow

all the steps indicated on the display and press

when

done to start each phase.

The average duration of the full function is around 190

minutes.

Please note: if the function is stopped at any time, the entire

descaling cycle must be repeated.

» DRAINING

Before descaling, it will be necessary to drain tank:

to perform the operation in the best way, proceed as

described in the relative paragraph.

Please note: it is not possible to perform this activity before 4

hours have elapsed from the last cycle (or the last time the

product was powered). During this wait time, the display will

show the following feedback “WATER IS HOT - PLEASE WAIT”.

The jug must be at least 2 liters large.

» DESCALING

For best results in descaling, we recommend filling

the tank with a solution composed of 75 g of the

specific WPRO product and 1.7 litres of drinking

water.

WPRO descaler is the suggested professional product

for the maintenance of the best performance of

your steam function in the oven. Please follow the

instructions for use on the packaging. For orders and

information contact the after sales service or

www.bauknecht.eu

Bauknecht will not be held responsible for any

damage caused by the use of other cleaning products

available on the market.

Once the descaling phase has been completed, the

tank has to be drained.

» RINSING

To clean the tank and the steam circuit, rinse cycle

has to be done. Fill the tank with drinking water until

the display shows “TANK FULL”, then press

to start

the rinsing. At the end, the display will prompt to

repeat this phase by draining and rinsing again.

Do not turn off the oven until all the steps required

by the function have been completed.

Cooking functions cannot be activated during the

cleaning cycle.

Please note: A message will be shown on display, to remind

you to execute this operation regularly.

. MINUTEMINDER

When the oven is switched off, the display can be

used as a timer. To activate this function, make sure

that the oven is switched off and press

or : The

icon will flash on the display.

Press

or to set the length of time you require and

then press

to activate the timer.

MINUTE-MINDER

An audible signal will sound and the display will

indicate once the minuteminder has finished

counting down the selected time.

Please note: The minuteminder does not activate any of the

cooking cycles. Press

or to change the time set on the

timer; press

or to switch the timer o at any time.

Once the minuteminder has been activated, you can

also select and activate a function.

Press

to switch on the oven and then select the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht BIK7 CSP8TS PT Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht BIK7 CSP8TS PT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info