Bedienungsanleitung Bauknecht GTE508 (Seite 2 von 4) (Englisch)

703659

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

and avour.

• Always leave hot food to cool before placing in the

appliance.

Freezing fresh food

• Place foods to be frozen in direct contact with the

walls of appliance:

A) - foods to be frozen,

B) - foods already frozen.

• Avoid placing foods to be frozen in direct contact

with food already frozen.

• For best and fastest freezing, foods should be split

into small portions; this will also be useful when the

frozen items are to be used.

• If minimum quantities of food are introduced (up to

1/4 of the maximum freezing power stated on the

rating plate), the operation of the appliance will be

controlled automatically by the

“Sensor”

function

without any need for intervention from the user.

• When freezing higher quantities of food, up to

the maximum freezing capacity of the appliance,

indicated on the rating plated, proceed as follows:

1. At least 24 hours before storing fresh foods

inside the product for freezing, activate the

fast freezing function by pressing (4) for

approximately 3 seconds. The green LEDS (3)

ash in sequence.

2. Introduce the food to freeze inside the appliance,

and keep the door of the appliance closed for 24

hours. After this period the food will be frozen.

The fast freezing function can be deactivated

manually by pressing (4).

If the fast freeze function is not manually deactivated,

it will be automatically deactivated by the appliance

after 50 hours.

FOOD STORAGE

Refer to the table on the appliance.

Classication of frozen foods

Load and classify the frozen foods; it is advisable

to indicate the storage date on the packs, to ensure

consumption before the expiry dates listed in months

in g. 6 for each type of food.

Advice for storing frozen food

When buying frozen food, make sure that:

• The packaging is intact (food in damaged

containers may have deteriorated). If a package

is swollen or has damp patches, the product may

not have been stored in optimum conditions and

therefore undergone partial defrosting.

• When shopping, leave frozen food purchases until

last and carry them in a thermally insulated bag.

• On arriving home, immediately place the frozen

food in the appliance.

• Avoid or minimise temperature variations. Observe

the expiry date on the packaging.

• Always follow the storage instructions on frozen

food packages.

Note:

• Eat fully or partially defrosted foods

immediately. Do not refreeze unless the food

is cooked after it has thawed. Once cooked,

the food can be refrozen.

• In case of a prolonged power failure:

Do not open the appliance door, except

to place ice packs (if provided) over the

frozen foods on the right and left side of the

appliance. This will slow down the rise in

temperature.

APPLIANCE DEFROSTING

The appliance should be defrosted when the

thickness of ice on the walls reaches 5-6 mm.

• Disconnect the appliance from the power supply.

• Remove food from the appliance and put it in a

very cool place or a thermally insulated bag.

• Leave the appliance door open.

• Remove the internal defrost water drain plug

(depending on model) (Fig. 8).

• Remove the external defrost water drain plug

(depending on model) and reposition it as shown in

gure 8.

• Use the separator (depending on model) inside

the product as a recipient for any remaining water,

(D) as shown in g. 8. If there is no separator, use

a shallow container.

• Defrosting can be sped up by using a spatula to

detach the frost from the appliance walls.

• Remove the frost from the bottom of the appliance.

• In order to avoid permanent damage to the

appliance interior, do not use pointed or sharp

metal instruments to remove the ice.

• Do not use abrasive products or heat up the

interior articially.

• Dry the inside of the appliance thoroughly.

• Ret the plug after defrosting.

CHANGING THE LID LIGHT BULB (if provided)

• Disconnect the appliance from the mains power

supply.

• Remove the diuser by following the sequence of

steps shown in the gure.

• Unscrew the light bulb and replace it with an

identical bulb of the same wattage and voltage.

• Ret the diuser and plug in the appliance.

TROUBLESHOOTING GUIDE

1. The red LED ashes.

• Is there a power failure?

• Is a defrosting operation in progress?

• Has fresh food recently been introduced?

• Is the appliance lid properly closed?

• Is the appliance placed near a heat source?

• Are the ventilation grille and condenser clean?

2. All LEDs ash at the same time.

• Contact the After-Sales Service.

3. The appliance is too noisy.

• Is the appliance perfectly horizontal?

• Is the appliance in contact with other furniture or

objects that may cause vibrations?

• Has the packaging been removed from under the

appliance?

Note: Gurgling noises from the refrigerating circuit

after the compressor cuts out are perfectly normal.

4. All LEDs are o and the product is not

working.

• Is there a power failure?

• Is the plug properly inserted in the socket?

• Is the electric cable intact?

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht GTE508 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht GTE508

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info