Bedienungsanleitung Be Cool Flow Iso-Fix (Seite 18 von 48) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

768101

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

NEVER UNDER ANY CIRCUMSTANCE should you

carry your baby in your arms in the car, or out of

the car seat. Although it may seem strange, in case

of an accident, even at only 40 km/hr the force is

such that it would be completely impossible to hold

onto your baby.

INSTRUCTIONS FOR ASSEMBLY AND USE

1. INSTALLING THE SAFETY SEAT

INSTALLATION from 9 kg up to 18 kg (76-105cm):

1a Slide the lsox anchors B (5) to their maximum length by

turning the lever A (17). Do this on both sides of the seat.

Open the cover (16) and take the top tether connector out (4).

1b Connect the lsox anchors until you hear them click into place.

The display window on the button (15) will turn from red to green.

Push the seat as far back as possible. Make sure that both lsox

are in the same position once you have pushed the seat back.

1c Connect the Top Tether in the anchor point intended for this in

the vehicle marked with the symbol:

Lastly, tighten the strap of the TT system until the green signal is

displayed on the indicator. The strap should go over the backrest

of the vehicle seat. If necessary raise the headrest or remove it.

The connector may be closed without being secured in the ISOFIX

anchor. Please make sure that the connectors are correctly

fastened into the anchor points of the vehicle by pulling the seat

once it has been installed.

To detach the seat follow the same steps in reverse: Move the

button (15) to open the connector and release the anchors.

INSTALLATION from 15 kg up to 36 kg (105-135cm):

Follow the same steps as before. In this case you should not

connect the Top Tether.

There is also the possibility of installing the seat only with the car

seat belt.

2. FASTENING THE CHILD INTO THE SAFETY SEAT

FLOW seat may be used for the following weight ranges:

9-18 kg using safety harness

15-36 kg the safety harness must be stored away and the child

should be secured with the vehicle seat belt.

SAFETY HARNESS 9KG-18KG

2a. Loosen the harness by pressing the button(10) and pulling

the diagonal part of the harness straps. Unfasten the buckle by

pressing the red button. Move the ends of the buckle to each side

of the seat so you can put the child in the seat. Position the child

in the seat and put the strap over him on the both sides, and then

fasten the buckle.

2b Tighten harness by pulling the lower strap A (11).

To get the child out of the seat follow the same process in reverse.

STORING THE SAFETY AWAY:

Once the child reached a weight of 18 kg (105 cm tall approx) the

harness should be stored away and the child should be secured

with the vehicle safety belt.

2c To store the harness away it needs to be fully loosen f irst, lift

the cover under the cushion and store the buckle parts in the

compartment.Then put the cover back on the seat.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Be Cool Flow Iso-Fix Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info