Bedienungsanleitung BeamZ 151.325 BAC504 ProPar (Seite 4 von 32) (Deutsch, Englisch, Holländisch, Französisch, Spanisch, Polnisch)

766832

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are

present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if

any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing

materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original

factory box and packing.

If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The

arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.

POWERSUPPLY

On the label on the backside of the fixture is indicated on this type of power supply must be connected. Check that the mains

voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The fixture must also

be directly connected to the mains and may be used. No dimmer or adjustable power supply.

Always connect the fixture to a protected circuit (circuit breaker or fuse). Make sure the fixture has an appropriate

electrical ground to avoid the risk of electrocution or fire.

INSTALLATION

Attention:

• The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight

for 1 hour without any harming deformation.

• The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.

This secondary safety attachment must be constructed in a way that no part of the installation can fall down

if the main attachment fails.

• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging

and servicing.

• The operator has to make sure that safety-relating and machine-technical installations are approved by an

expert before taking into operation for the first time and after changes before taking into operation another

time.

• The operator has to make sure that safety-relating and machine-technical installations are approved by a

skilled person once a year.

• The fixture should be installed in the position where persons cannot reach and where persons may walk by

or be seated.

CAUTION: Please consider the respective national norms during the

installation! The installation must only be carried out by an

authorized employee or dealers!

CAUTION: When installing the fixture, make sure there is no highly in

inflammable material (decoration articles, etc.) in between a

distance of min 0.5 meter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BeamZ 151.325 BAC504 ProPar Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info