Bedienungsanleitung BEKO CWB 9910 (Seite 7 von 44) (Englisch, Dänisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

528185

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

- 7 -

GENERAL

Carefully read the following important information

regarding installation safety and maintenance. Keep this

information booklet accessible for further consultations.

The appliance has been designed for use in the ducting

version (air exhaust to the outside – Fig.1B), filtering

version (air circulation on the inside – Fig.1A) or with

external motor (Fig.1C).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating simulta-

neously with an open fireplace or burner that depend on

the air in the environment and are supplied by other than

electrical energy, as the cooker hood removes the air

from the environment which a burner or fireplace need

for combustion. The negative pressure in the environment

must not exceed 4Pa (4x10-5 bar). Provide adequate

ventilation in the environment for a safe operation of the

cooker hood. Follow the local laws applicable for external

air evacuation.

Before connecting the model to the electricity net-

work:

- Control the data plate (positioned inside the appliance)

to ascertain that the voltage and power correspond to

the network and the socket is suitable. If in doubt ask a

qualified electrician.

- If the power supply cable is damaged, it must be

replaced with another cable or a special assembly, which

may be obtained direct from the manufacturer or from

the Technical Assistance Centre.

2. WARNING !

In certain circumstances electrical appliances may

be a danger hazard.

A) Do not check the status of the filters while the

cooker hood is operating

B) Do not touch bulbs or adjacent areas, during or

straight after prolonged use of the lighting

installation.

C) Flambè cooking is prohibited underneath the

cooker hood

D) Avoid free flame, as it is damaging for the filters

and a fire hazard

E) Constantly check food frying to avoid that the

overheated oil may become a fire hazard

F) Disconnect the electrical plug prior to any main-

tenance.

G) This appliance is not intended for use by young

children or infirm persons without supervision

H) Young children should be supervised to ensure

they do not play with the appliance

I) There shall be adequate ventilation of the room

when the rangehood is used at the same time as ap-

pliances burning gas or other fuels

L) There is a risk of fire if cleaning is not carried out

in accordance with the instructions

This appliance conforms to the European Directive EC/

2002/96, Waste Electrical and Electronic Equipment

(WEEE). By making sure that this appliance is disposed

of in a suitable manner, the user is helping to prevent

potential damage to the environment or to public health.

The

symbol on the product or on the accompanying

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to a

suitable electric and electronic appliance recycling

collection point. Follow local guidelines when disposing

of waste. For more information on the treatment, re-use

and recycling of this product, please contact your local

authority, domestic waste collection service or the shop

where the appliance was purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried

out by specialised personnel.

• Electric Connection

The appliance has been manufactured as a class II,

therefore no earth cable is necessary.

The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load

indicated on the description label. Where a plug is pro-

vided, the cooker hood must be installed in order that

the plug is easily accessible.

An omnipolar switch with a minimum opening of 3mm

between contacts, in line with the electrical load and

local standards, must be placed between the appliance

and the network in the case of direct connection to the

electrical network.

• The distance between the surface supporting the

cooking containers on the cooking device and the bottom

of the kitchen hood must be a minimum of 65 cm (if it is

a gas hob) and 45 cm (if it is an electric or induction

heating system hob).

If a connection tube composed of two parts is used,

the upper part must be placed outside the lower part.

Do not connect the cooker hood exhaust to the same

conductor used to circulate hot air or for evacuating

fumes from other appliances generated by other than

an electrical source.

• In the case of assembly of the appliance in the suction

version prepare the hole for evacuation of the air.

• We recommend the use of an air exhaust pipe with

a diameter of 150. If a pipe with a smaller diameter is

used, the efficiency of the product may be reduced

and its operation may become noisier

• Before starting to fix the hood, disconnect the anti-

grease filter B (Fig.6) for easier appliance handling.

Before this operation, perform the following steps

depending on the model purchased:

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO CWB 9910 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info