Bedienungsanleitung BEKO HBV60X (Seite 6 von 12) (Englisch)

556808

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

ENGLISH

GENERAL

Carefully read the following important information regarding

installation safety and maintenance. Keep this information

booklet accessible for further reference. The appliance has

been designed for use in the ducting version (air exhaust to

the outside – Fig.1B), filtering version (air circulation on the

inside – Fig.1A) or with external motor (Fig.1C).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating simultaneously

with an open fireplace or burner that depend on the air in the

environment and use a fuel source other than electrical energy,

as the cooker hood removes the air from the environment

which a burner or fireplace need for combustion. The negative

pressure in the environment must not exceed 4Pa (4x10-5 bar).

Provide adequate ventilation in the environment for a safe

operation of the cooker hood.Follow the local laws applicable

for external air evacuation.

Before connecting the model to the electricity network:

- check the data plate (positioned inside the appliance) to

ascertain that the voltage and power correspond to the

network and the socket is suitable. If in doubt ask a qualified

electrician.

- If the power supply cable is damaged, it must be replaced

with another cable or a special assembly, which may be

obtained direct from the manufacturer or from the Technical

Assistance Centre.

- This device must be connected to the supply network

through either a plug fused 3A or hardwired to a 2 phase

spur protected by 3A fuse.

2. Warning !

In certain circumstances electrical appliances may be a

danger hazard.

A) Do not check the status of the filters while the cooker

hood is operating

B) Do not touch bulbs or adjacent areas, during or straight

after prolonged use of the appliance.

C) Flambè cooking is prohibited underneath the cooker

hood

D) Avoid leaving exposed flames and always ensure that

the burners are covered as open flames are damaging for

the filters and a fire hazard

E) Constantly check food frying to avoid overheated oil

becoming a fire hazard

F) Disconne ct the electri cal plug prior to an y

maintenance.

G) This appliance is not intended for use by young children

or infirm persons without supervision

H) Young children should be supervised to ensure they

do not play with the appliance

I) There shall be adequate ventilation of the room when

the rangehood is used at the same time as appliances

burning gas or other fuels

L) There is a risk of fire if cleaning is not carried out in

accordance with the instructions

This appliance conforms to the European Directive EC/2002/96,

Waste Electrical and Electronic Equipment (WEEE). By making

sure that this appliance is disposed of in a suitable manner,

the user is helping to prevent potential damage to the

environment or to public health.

The symbol on the product or on the accompanying

paperwork indicates that the appliance should not be treated

as domestic waste, but should be delivered to a suitable

electric and electronic appliance recycling collection point.

Follow local guidelines when disposing of waste. For more

information on the treatment, re-use and recycling of this

product, please contact your local authority, domestic waste

collection service or the shop where the appliance was

purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out by

specialised personnel.

• Electrical Connection

The appliance has been manufactured as a class II, therefore

no earth cable is necessary.

The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load

indicated on the description label. Where a plug is provided,

the cooker hood must be installed in order that the plug is

easily accessible.

An omnipolar switch with a minimum opening of 3mm

between contacts, in line with the electrical load and local

standards, must be placed between the appliance and the

network in the case of direct connection to the electrical

network.

• The minimum distance between the support surfaces of

the cooking pots on the cooker top and the lowest part of

the cooker hood must be at least 65 cm. If a connection

tube composed of two parts is used, the upper part must be

placed outside the lower part. Do not connect the cooker

hood exhaust to the same conductor used to circulate hot air

or for evacuating fumes from other appliances generated by

other than an electrical source. Before proceeding with the

assembly operations, remove the anti-grease filter(s) (Fig.6)

so that the unit is easier to handle.

- In the case of assembly of the appliance in the suction version

prepare the hole for evacuation of the air.

• We recommend the use of an air exhaust tube which has the

same diameter as the air exhaust outlet hole. If a pipe with a

smaller diameter is used, the eciency of the product may be

reduced and its operation may become noisier.

• Warning: if the bulbs are not working, ensure that they are

screwed in fully.

• Installation

Prior to proceeding with the assembly operations (according

to the model that you have purchased), to facilitate handling

of the device, remove the grille as indicated in Fig. 5.

• The appliance is equipped with 2 air outlets, to be used in

accordance with your specic requirements: one is located on

the upper part of the appliance and the other at the rear (Fig.

- 6 -

BEKO HBV60X Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info