Bedienungsanleitung BEKO HNU51310S (Seite 9 von 40) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

677685

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

EN - Instruction on mounting and use

Closely follow the instructions set out in this manual. All responsibility,

for any eventual inconveniences, damages or fires caused by not complying

with the instructions in this manual, is declined. The hood is conceived for

the suction of cooking fumes and steam and is destined only for domestic

use. Note: the elements marked with the symbol “(*)” are optional

accessories supplied only with some models or elements to purchase, not

supplied.

Caution

WARNING! Do not connect the appliance to the mains until the installation is

fully complete. Before any cleaning or maintenance operation, disconnect

hood from the mains by removing the plug or disconnecting the mains

electrical supply. Always wear work gloves for all installation and

maintenance operations. The appliance is not intended for use by children or

persons with impaired physical, sensorial or mental faculties, or if lacking in

experience or knowledge, unless they are under supervision or have been

trained in the use of the appliance by a person responsible for their safety.

This appliance is designed to be operated by adults, children should be

monitored to ensure that they do not play with the appliance. This appliance

is designed to be operated by adults. Children should not be allowed to

tamper with the controls or play with the appliance. Never use the hood

without effectively mounted grating! The hood must NEVER be used as a

support surface unless specifically indicated. The premises where the

appliance is installed must be sufficiently ventilated, when the kitchen hood

is used together with other gas combustion devices or other fuels. The

ducting system for this appliance must not be connected to any existing

ventilation system which is being used for any other purpose such as

discharging exhaust fumes from appliances burning gas or other fuels. The

flaming of foods beneath the hood itself is severely prohibited. The use of

exposed flames is detrimental to the filters and may cause a fire risk, and

must therefore be avoided in all circumstances. Any frying must be done

with care in order to make sure that the oil does not overheat and ignite.

Accessible parts of the hood may became hot when used with cooking

appliance. With regards to the technical and safety measures to be adopted

for fume discharging it is important to closely follow the regulations provided

by the local authorities. The hood must be regularly cleaned on both the

inside and outside (AT LEAST ONCE A MONTH). This must be completed in

accordance with the maintenance instructions provided in this manual).

Failure to follow the instructions provided in this user guide regarding the

cleaning of the hood and filters will lead to the risk of fires. Do not use or

leave the hood without the lamp correctly mounted due to the possible risk of

electric shocks. We will not accept any responsibility for any faults, damage

or fires caused to the appliance as a result of the non-observance of the

instructions included in this manual. This appliance is marked according to

the European directive 2002/96/EC on Waste Electrical and Electronic

Equipment (WEEE). By ensuring this product is disposed of correctly, you

will help prevent potential negative consequences for the environment and

human health, which could otherwise be caused by inappropriate waste

handling of this product.

The symbol

on the product, or on the documents accompanying the

product, indicates that this appliance may not be treated as household

waste. Instead it should be taken to the appropriate collection point for the

recycling of electrical and electronic equipment. Disposal must be carried out

in accordance with local environmental regulations for waste disposal.

For further detailed information regarding the process, collection and

recycling of this product, please contact the appropriate department of your

local authorities or the local department for household waste or the shop

where you purchased this product. Additional Installation Specifications:

Use only the fixing screws supplied with the product for installation. Use the

correct length screws which are identified in the Installation Guide

WARNING! Failure to install the screws or fixing device in accordance with

these instructions may result in electrical hazards.

Use

The hood is designed to be used either for exhausting

or filter

version

Installation

The minimum distance between the supporting surface for the cooking

equipment on the hob and the lowest part of the range hood must be not

less than 6

0cm from electric cookers and 65cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater distance,

this must be adhered to.

The mains power supply must correspond to the rating indicated on the plate

situated inside the hood. If provided with a plug connect the hood to a socket

in compliance with current regulations and positioned in an accessible area,

after installation. If it not fitted with a plug (direct mains connection) or if the

plug is not located in an accessible area, after installation, apply a double

pole switch in accordance with standards which assures the complete

disconnection of the mains under conditions relating to over-current category

III, in accordance with installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and

checking the efficient function, always check that the mains cable is correctly

assembled.

Operation

The hood is fitted with a control panel with aspiration speed selection control

and a light switch to control cooking area lights.

Use the high suction speed in cases of concentrated kitchen vapours. It is

recommended that the cooker hood suction is switched on for 5 minutes

prior to cooking and to leave in operation during cooking and for another 15

minutes approximately after terminating cooking.

Maintenance

ATTENTION! Before performing any maintenance operation, isolate the

hood from the electrical supply by switching off at the connector and

removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the

plug must be removed from the socket.

The cooker hood should be cleaned regularly (at least with the same

frequency with which you carry out maintenance of the fat filters) internally

and externally. Clean using the cloth dampened with neutral liquid

detergent. Do not use abrasive products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the

cooker hood and replacement of the filters may cause fire risks.

Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to the motor or

any fire damage linked to inappropriate maintenance or failure to observe

the above safety recommendations.

Grease filter

Fig. 3-5-7

If situated inside the support grill, it may be one of the following types:

Paper filter must be replaced once a month or if colouring appears on

upper side, in such cases the colouring is evident through the grill openings.

Metallic filter must be cleaned once a month, with non abrasive detergents,

by hand or in dishwasher on low temperature and short cycle.

When washed in a dishwasher, the grease filter may discolour slightly, but

this does not affect its filtering capacity.

Charcoal filter (filter version only)

Fig. 6

The saturation of the charcoal filter occurs after more or less prolonged

use, depending on the type of cooking and the regularity of cleaning of the

grease filter.

In any case it is necessary to replace the cartridge at least every four

mounths.

The charcoal filter may NOT be washed or regenerated.

Replacing lamps

Disconnect the hood from the electricity.

Warning! Prior to touching the light bulbs ensure they are cooled down.

Replace the damaged lamp.

Use Ø35mm E14 28W halogen candle lamps only.

BEKO HNU51310S Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info