Bedienungsanleitung BEKO WMB 51221 C (Seite 59 von 76) (Deutsch, Englisch, Holländisch, Französisch)

676601

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

situations and to ensure smooth water intake

and discharge of the machine, ﬁx the end of

the discharge hose tightly so that it cannot

come out.

• The hose should be attached to a height of at

least 40 cm, and 100 cm at most.

• In case the hose is elevated after laying it on

the ﬂoor level or close to the ground (less than

40 cm above the ground), water discharge

becomes more difﬁcult and the laundry may

come out excessively wet. Therefore, follow

the heights described in the ﬁgure.

100cm

40cm

• To prevent ﬂowing of dirty water back into the

machine and to allow for easy discharge, do

not immerse the hose end into the dirty water

or drive it in the drain more than 15 cm. If it is

too long, cut it short.

• The end of the hose should not be bent, it

should not be stepped on and the hose must

not be pinched between the drain and the

machine.

• If the length of the hose is too short, use it

by adding an original extension hose. Length

of the hose may not be longer than 3.2 m.

To avoid water leak failures, the connection

between the extension hose and the drain

hose of the product must be ﬁtted well with

an appropriate clamp as not to come off and

leak.

Adjusting the feet

In order to ensure that the product operates

more silent and vibration-free, it must stand

level and balanced on its feet. Balance the

machine by adjusting the feet. Otherwise, the

product may move from its place and cause

crushing and vibration problems.

1. Loosen the lock nuts on the feet by hand.

2. Adjust the feet until the product stands level

and balanced.

3. Tighten all lock nuts again by hand.

Do not use any tools to loosen the lock nuts.

Otherwise, they will get damaged.

Electrical connection

Connect the product to a grounded outlet

protected by a fuse complying with the values in

the "Technical speciﬁcations" table. Our company

shall not be liable for any damages that will arise

when the product is used without grounding in

accordance with the local regulations.

• Connection must comply with national

regulations.

• Power cable plug must be within easy reach

after installation.

• The voltage and allowed fuse or breaker

protection are speciﬁed in the “Technical

speciﬁcations” section. If the current value of

the fuse or breaker in the house is less than

16 Amps, have a qualiﬁed electrician install a

16 Amp fuse.

• The speciﬁed voltage must be equal to your

mains voltage.

• Do not make connections via extension

cables or multi-plugs.

Damaged power cables must be replaced by

the Authorized Service Agents.

First use

Before starting to use the product, make sure

that all preparations are made in accordance

with the instructions in sections "Important safety

instructions" and "Installation".

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMB 51221 C Seite 59

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info