Bedienungsanleitung BEKO WMB71642 (Seite 10 von 40) (Englisch)

556825

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

• Do not make connections via extension

cables or multi-plugs.

Damaged power cables must be

replaced by the Authorized Service

Agents.

Electrical requirements

Before you insert the plug into the wall socket

make sure that the voltage and the frequency

shown in the rating label corresponds to your

electricity supply.

We recommend that this appliance be

connected to the mains supply via a suitable

switched and fused socket in a readily

accessible position.

Should the mains lead of the appliance

become damaged or need replacing at any

time, it must be replaced by a special purpose

made mains lead which can only be obtained

from a Authorised Service Agent.

This appliance must be earthed

If the fitted moulded plug is not suitable for

your socket, then the plug should be cut off

and an appropriate plug fitted.

Destroy the old plug, which is cut off as a

plug with a bared cord could cause a shock

hazard if inserted into a socket elsewhere in

the house.

The moulded plug on this appliance

incorporates a 13A fuse. Should the fuse

need to be replaced an ASTA approved

BS1362 fuse of the same rating must be

used. Do not forget to refit the fuse cover.

In the event of losing the fuse cover, the

plug must not be used until a replacement

fuse cover has been fitted. Colour of the

replacement fuse cover must be the same

colour as that visible on the pin face of the

plug. Fuse covers are available from any good

electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains lead

of this appliance may not correspond with the

coloured markings identifying the terminals on

your plug, proceed as follows:

1 Connect the green - yellow or green

(earth) wire to the terminal in the plug

marked ‘E’ or with the symbol f or

coloured green and yellow or green.

2 Connect the blue (neutral) wire to the

terminal in the plug marked ‘N’ or

coloured black.

3 Connect the brown (live) wire to the

terminal in the plug marked ‘L’ or

coloured red.

With the alternative plugs a 13A fuse must be fitted

either in the plug or adaptor or in the main fuse

box. If in doubt contact a qualified electrician.

First use

Before starting to use the product, make sure

that all preparations are made in accordance

with the instructions in sections "Important

safety instructions" and "Installation".

To prepare the product for washing laundry,

perform first operation in Drum Cleaning

programme. If your machine is not featured

with Drum Cleaning programme, use

Cottons-90 programme and select Additional

Water or Extra Rinse auxiliary functions as

well. Before starting the programme, put max.

100 g of powder anti-limescale into the main

wash detergent compartment (compartment

nr. II). If the anti-limescale is in tablet form, put

only one tablet into compartment nr. II. Dry the

inside of the bellow with a clean piece of cloth

after the programme has come to an end.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMB71642 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info