Bedienungsanleitung BEKO WMI 71641 (Seite 25 von 48) (Englisch)

528055

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Preparation

1. Turn the tap on completely. Check that

the hose is connected tightly.

2. Placethelaundryinthemachine.

3. Add detergent and softener.

Starting

1. Pressthe“On/Off”button.

2. SelecttheProgrammeandthe

temperature.

3. Ifdesired(accordingtoyourmachine’s

model):

– selectanyauxiliaryfunction,

– adjustthespinspeed,

– setthetimedelay,

4. Close the loading door.

5. Press“Start/Pause/Cancel”button.

The display shows the time remaining for

theProgrammetocompleteiftimedelay

is not set.

The display shows the time remaining for

theProgrammetostartifthetimedelayis

set.

6. Check if the Door Locked Symbol

lights up on the screen.

TheDoorLockedSymbol(Figure3-2i)will

light up if time delay is not set.

TheDoorLockedSymbol(Figure3-2i)will

fade if time delay is set.

Cancelling a Programme

1. Pressandholdthe“Start/Pause/

Cancel”buttonforabout3seconds;

the Start symbol will start flashing.

2. The machine can discharge all the

water or can take in water for 3 times

at most to cool down the clothes and

complete discharging process.

Adding more laundry

•

This is only possible under the

followingconditions:

– duringtimedelay,

Youmayaddorremovelaundryduring

thetimedelay(untiltheProgramme

starts).Atthebeginningofawashing

cycle(machineallowsaddingmore

laundry during a future step only if the

water level is low enough to open the

loading door or if the temperature in

themachineislow).

In order to add laundry after the start-

upoftheProgramme:

1. Press“Start/Pause/Cancel”button.

2. Opentheloadingdoorandputin

more laundry.

3. Close the loading door.

4. Press“Start/Pause/Cancel”button.

Programme is in rinse hold mode

This process is shown with the

flashing spin symbol and the standby

symbol which is lit up.

If you wish to spin when the machine is in

thismode:

1. Adjust the spin speed.

2. Press“Start/Pause/Cancel”button.

TheProgrammecontinues,pumpsout

the water and spins.

3. The standby symbol fades out and the

start symbol lights up.

If you want to discharge the water without

spinning:

1. Press“Start/Pause/Cancel”button.

2. The standby symbol fades out and the

start symbol lights up.

3. TheProgrammecontinuesandonly

pumps out the water.

Re-spinning the laundry

The control system for an unbalanced load

can pause the spinning in cases when the

distribution of the laundry in the drum is

not balanced.

Ifyouwanttore-spintheclothes:

1. Distribute the laundry in your machine

for a balanced load.

2. SelectthespinProgramme.

3. Adjust the spin speed.

After the Programme is finished

Programmeindicatorsymbolsonthe

screenwillremainlitaftertheProgramme

isfinished.“End”willappearonthe

screen.

1. Opentheloadingdoorandtakeout

the laundry when the door locked

symbol on the display fades out.

2. Pressthe“On/Off”button.

3. Turn the water tap off.

4. Remove any folds in the rubber seal

on the loading door and check for

debris.

5. Leave the loading door and detergent

drawer open to dry.

Quick instructions for daily use

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMI 71641 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info