Bedienungsanleitung BEKO WTV6611BC1 (Seite 20 von 60) (Deutsch, Englisch)

757479

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

20 / EN Washing Machine / User Manual

Adding or taking out laundry

You can load/unload laundry when a programme is running if the water level is appropriate to open

the door. To do this:

1. Press Start / Pause button to switch the machine to pause mode. The programme follow-up light

of the relevant step during which the machine was switched into the pause mode will flash.

2. Wait until the Loading Door can be opened.

3. Open the Loading Door and add or take out the laundry.

4. Close the Loading Door.

5. Make changes in speed settings, if necessary.

6. Press Start / Pause button to start the machine.

4.3.15 Cancellng the programme

To cancel the programme, turn the Programme Selection knob to select another programme.

Previous programme will be cancelled. End / Cancel light will flash continuously to notify that the

programme has been canceled.

Your machine will end the programme when you turn the Programme Selection knob; however, it

does not drain the water inside. When you select and start a new programme, the newly selected

programme will start depending on the step the previous programme was canceled in. For example,

it may take in additional water or continue to wash with the water inside.

Some programmes may start by discharging the water inside the machine. Depending on the step where the

programme was canceled in, you may have to put detergent and softener again for the programme you have

selected anew.

4.3.16 End of programme

When the programme ends, "End" LED becomes on at the Programme Follow-up indicator.

1. Wait until the "Door Lock Enabled LED" goes off completely.

2. To switch off the machine, turn the Programme Selection Knob to On/Off position.

3. Take out your laundry and close the loading door. Your machine is ready for the next washing

cycle.

4.3.17 Your machne features "Pause Mode".

After you switch on your machine with the programme selection button (by switching the button

to a different position than the On/Off position), if no programme is started or no other procedure

is performed in the selection step or no action is taken within approx. 2 minutes after the selected

programme ends, your machine will switch to energy saving mode automatically. The brightness of

the indicator lights will decrease. Also, if your product has a display that shows programme time, this

display will be completely turned off. If you turn the Programme Selection knob or touch any button,

lights and display will switch back to previous condition. The selections which you make when exiting

from the energy efficiency may change. Please check the correctness of your selections before

starting the programme. If necessary, please make your settings again. This is not an error.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WTV6611BC1 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO WTV6611BC1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info