Bedienungsanleitung BEKO WTV77111BW01 (Seite 21 von 60) (Deutsch, Englisch)

757602

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Washing Machine / User Manual 21 / EN

4.4 Maintenance and cleaning

Service life of product extends and frequently experienced problems will be reduced if it is cleaned at

regular intervals.

4.4.1 Cleanng the detergent drawer

Clean the detergent drawer at regular intervals (every 4-5 washing cycles)

as shown below in order to prevent accumulation of powder detergent in

time.

1 Press the dotted point on the siphon in the softener compartment and pull towards you until

the compartment is removed from the machine.

2. Lift the rear part of the siphon to remove it as illustrated. If more than normal amount of water

and softener mixture starts to gather in the softener compartment, the siphon must be cleaned.

3. Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin.

In order to prevent the residues to contact your skin, clean it with an appropriate brush by

wearing a pair of gloves.

4. Insert the drawer back into its place after cleaning and make sure that it is seated well.

4.4.2 Cleanng the loadng door and the drum

For products with drum cleaning programme, please see Operating the product - Programmes.

Repeat Drum Cleaning process in every 2 months.

Use an detergent / anti-limescale suitable for the washing machines.

After every washing make sure that no foreign substance is left in the drum.

If the holes on the bellow shown in the figure is blocked, open the holes using

a toothpick.

Foreign metal substances will cause rust stains in the drum. Clean the stains

on the drum surface by using cleaning agents for stainless steel.

Never use steel wool or wire wool. These will damage the painted, chromated

and plastic surfaces.

4.4.3 Cleanng the body and control panel

Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary,

and dry with a soft cloth.

Use only a soft and damp cloth to clean the control panel.

4.4.4 Cleanng the water ntake flters

There is a filter at the end of each water intake valve at the rear of the machine and also at the end of

each water intake hose where they are connected to the tap. These filters prevent foreign substances

and dirt in the water to enter the washing machine. Filters should be cleaned as they do get dirty.

1. Close the taps.

2. Remove the nuts of the water intake hoses to

access the filters on the water intake valves.

Clean them with an appropriate brush. If the

filters are too dirty, remove them from their

places with a pliers and clean in this way.

3. Take out the filters on the flat ends of the water

intake hoses together with the gaskets and clean

thoroughly under running water.

4. Replace the seals and filters carefully and tighten

their nuts by hand ensuring there are no leaks.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WTV77111BW01 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO WTV77111BW01

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info