Bedienungsanleitung Beper BC001 (Seite 13 von 44) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

710519

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Espresso machine Use instructions

3 - Fill a jug with about 150 grams of milk for each cappuccino to be prepared, you are recommen-

ded to use whole milk at refrigerator temperature (not hot!).

Note: In choosing the size of jug, it is recommend the diameter is not less than 70±5mm, and bear in

mind that the milk increases in volume by 2 times, make sure the height of jug is enough.

4 - Insert the steam wand(with the frothing device) into the milk about two centimetre, then turn the

knob to the “ ” position , steam will come out from the steam wand. Froth milk in the way moving

vessel round from up to down.

5. When the required purpose is reached, you can turn the knob to the “ ” position.

Note: Clean steam outlet with wet sponge immediately after steam stops generating, but care not

to hurt!

6. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten to taste

and if desired, sprinkle the froth with a little cocoa powder.

7. Press the power switch to cut off the power source.

Note:Before making coffee again.You should turn the knob to the “ ” position and press the

steam button to the higher position which is the “ ” position, the pump will pump water until the

ready indicator is went out then turn the knob to the“ ” position and wait until the indicator lights

up blue again.

Producing steam to heat liquids

The steam wand (without the frothing device) can be used to make hot beverages like drinking

chocolate, and water.

Method:

1. Remove the detachable tank and ll it with desired water, the water level should not exceed the

“MAX” mark in the tank. Then place the tank into the appliance properly.

2. Then connecting the appliance to power supply source.

3. Press the ON/OFF switch, the power indicator (red) is illuminated.

4.Turn the knob to the “ ” position, make sure the steam button is on the higher position which is

the“ ”position, the pump will pump water, when there is water owing out, close the pump imme-

diately, pressing down the steam button to the lower position which is the “ ” position and waiting

for a moment, the appliance begins to be heated until the yellow lamp is illuminated, it shows the

heating is nish.

5. Remove the frothing device from the steam wand.

6. Dip the steam wand into the liquid to be heated. Turn the knob to the “ ” position.

7. When the required temperature is reached, you can turn the knob to the“ ” position.

8. Press the power switch to cut off the power source.

Automatically power-off function

1. After pressing power switch, if there is no any operation within 25 minutes, the unit will power off

automatically.

2. After pressing power switch, if there is no any operation after pump worked for 3 minutes during

brewing coffee, the unit will power off automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beper BC001 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info