Bedienungsanleitung Bertazzoni WD60CONX-12 (Seite 7 von 16) (Englisch)

605243

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Installation instructions

Before installation

Check that the input voltage indicated on the

characteristics plate is the same as the voltage of

the power outlet you are going to use.

Open the drawer and take out all the

accessories and remove the packing material.

Attention! The front surface of the crockery

heater may be wrapped in a protective film.

Before using the warming drawer for the first

time, remove this film carefully.

Make sure that the warming drawer is not

damaged in any way. Check that the drawer

opens and closes correctly. If you find any

damage, contact the Technical Assistance

Service.

Attention: the power socket should be easily

accessible after the warming drawer has been

installed.

The warming drawer should only be built-in in

combination with those appliances indicated by

the manufacturer. If it is fitted in combination

with other appliances, the guarantee is no

longer valid since it is impossible to

guarantee that the warming drawer will work

correctly.

Installation

To build-in the warming drawer in combination

with another appliance there must be a fixed,

interim shelf in the housing unit to support the

weight of both appliances.

The appliance to be combined with the warming

drawer will be placed directly on the latter without

any need to have a separating shelf.

To build-in the appliance which is combined with

the warming drawer, follow the instructions set

out in the respective instructions and fitting

booklet.

The relevant installation dimensions are indicated

in mm in the diagrams shown at the end of

this booklet. Proceed as follows:

1. Place the warming drawer on the shelf and

slide it towards the interior of the niche in

such a way that it is centred and completely

lined up with the front of the unit.

2. Check that the warming drawer’s frame is

properly levelled and is sitting evenly on the

shelf.

3. Open the drawer and fix the warming

drawer to the sides of the unit using the two

screws provided.

Electrical Connection

The warming drawer is equipped with a power

cable and plug for single phase current. We

advise that the plug is connected to a socket

that is easily accessible after installation.

If the warming drawer is to be installed on a

permanent basis it should be installed by a

qualified technician. In such a case, the

appliance should be connected to a circuit with

an all-pole circuit breaker with a minimum

separation of 3 mm between contacts.

The data necessary for the electrical connection

are described on the warming drawer’s

characteristics plate and these must be

compatible with those of the power outlet you are

going to use.

WARNING: THE WARMING DRAWER MUST

BE CONNECTED TO EARTH.

The manufacturer and retailers do not accept

responsibility for any damage that may be

caused to people, animals or property if these

installation instructions are not observed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bertazzoni WD60CONX-12 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info