Bedienungsanleitung Bestway 58259 (Seite 3 von 6) (Englisch)

752356

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Safety Instructions

WARNING

When installing and using this electrical appliance, basic safety precautions

should always be followed, including the following:

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

WARNING:

• The Pool Heater must be tested before each use.

• The Pool Heater must be supplied through a residual current device (RCD)

having a rated residual operating current not exceeding 30mA.

• Parts containing live parts, except parts supplied with safety extra-low

voltage not exceeding 12V, must be inaccessible to a person in the pool;

Parts incorporating electrical components, except remote control devices,

must be located or fixed so that they cannot fall into the swimming pool.

• The plug of Pool Heater shall be more than 3.5m away from the swimming

pool.

• RISK OF ELECTRIC SHOCK - The Pool Heater can not be used while

people are inside the pool.

• If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

• To reduce the risk of electric shock, do not use extension cords to connect

the unit to electric supply; provide a properly located outlet.

• Do not bury cord. Locate cord to minimize abuse from lawn mowers, hedge

trimmers, and other equipment.

• Do not switch on if there is a possibility that the water in the Pool Heater is

frozen.

• It is necessary to have the plug accessible after installation of the pool.

• Before using the Pool Heater, make sure the pool has been filled with

water.

• Pool Heaters are designed for used with specific water volume; ensure

your Pool Heater matches your pool’s water volume along with your Filter

Pump or Sand Filter’s designated water flow rate.

• RISK OF ELECTRIC SHOCK - Install at least 2m from all metal

surfaces.

• This appliance is not intended for use by persons (including children) with

reduced physical, sensor or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the

appliance.

• To reduce the risk of injury, do not permit children to use this product

unless they are closely supervised at all times.

CAUTION:

• Pool Heater is for use with storable pools only. Do not use with

permanently-installed pools. A storable pool is constructed so that it is

capable of being readily disassembled for storage and reassembled to its

original integrity. A permanently-installed pool is constructed in or on the

ground or in a building such that it cannot be readily disassembled for

storage.

• Never add water to chemicals. Always add chemicals to water to avoid

strong fumes or violent reactions that may result in hazardous chemical

spray.

• The Pool Heater should not be setup or left out in temperature lower than

4°C (40°F).

NOTE:

• Ensure the Pool Heater is at least 2 meters away from poolside. Keep

distance as far as possible.

• Handle the Pool Heater with care. Do not pull or carry the Pool Heater by

the power cord. Keep cords free from abrasions. Sharp objects, oil,

moving parts, and heat should never be exposed to the Pool Heater.

• Please examine all equipment before use. Notify Bestway through our

customer service address listed on this manual for any damaged or

missing parts at the time of purchase. Verify all components represent the

model that you purchased.

• This product is not intended for commercial use.

IMPORTANT: Using the Pool Heater with an unmatched electrical supply is

dangerous and will result in catastrophic failure of the Pool Heater.

SAVE THESE INSTRUCTIONS

Meaning of crossed –out wheeled dustbin: Do not dispose of electrical

appliances as unsorted municipal waste, use separate collection

facilities.Contact your local government for information regarding the

collection systems available. If electrical appliances are disposed of in

landfills or dumps, hazardous substances can leak into the

groundwater and get into the food chain, damaging your health and well-being.

When replacing old appliances with new ones, the retailer is legally obligated

to take back your old appliance for disposals at least free of charge.

Disposal

Specifications

Voltage:

Power:

Frequency:

Max. Heat Capability:

Increased Heat Rate (*):

Suitable Pool Water Volume:

Filter Pump/Sand Filter

Compatibility:

Pool Compatibility:

220-240V

2,800W at 20°C

50Hz

40°C

Approximately 0.5°C/h-1.5°C/h

depending on total water volume

400-5,000gal (1,520-18,930 L)

3,785 L/h (1,000 gal/h) and below

3,785 L/h (1,000 gal/h)

15’ and smaller

WARNING: The pool heater must be located in zone 2 or outside all zones.

The pool heater can not be put into the pool.

Zone 2 Zone 1

Zone 0

Zone 22.5m

2.5m

1.5m1.5m 2m2m

NOTE: The Increased Heat Rate is just for reference. The actual heating time may vary according to the pool’s water volume, environmental temperatures,

desired temperatures and other conditions. Usually, if the pool has a large water volume or if environment temperatures are low and the desired temperature

is high, longer heating time is required. However, if the temperature increase is less than 0.2°C after one heating hour, the water temperature can be thought

to have reached the highest balance temperature.

Installation Directions

Problem Cause

Troubleshooting

Solution

A. Power failure. A. Check power source.

A. The Pool Heater is not working

B. Heating time is too long

C. Filter pump or Sand Filter does not match the Pool

Heater appropriately or Filter Pump or Sand Filter

failed, resulting in high or low water flow rates.

D. Pool Heater set-up failed

E. The thermal cut out cut off

F. Pool Heater failed

A. Check the LED light to see whether the heater is working

B. Highly recommend the use of a Bestway pool cover

C. Filter Pump or Sand Filter needs to be replaced or repaired.

D. Reset-up the Pool Heater according to the instructions.

E. Press the “Reset” button on the Pool Heater

F. Contact after-sales service

A. Hose Clamps are loose

B. Hose O-ring not in correct position

C. Hose Broken

A. Tighten the hose clamps

B. Check whether O-Ring are damaged.

C. Hose needs to be replaced

A. Filter Pump or Sand Filter does not work

B. Filter Pump or Sand Filter broken

A. Reset-up the Filter Pump or Sand Filter according to the

instructions.

Check and repair the Filter Pump or Sand Filter according to

the relevant instructions in the Filter Pump or Sand Filter’s

owner’s manual.

A. The light is broken.

A. The heating light is wrong and the heater still works.

1. The heating light does not work.

3. Pool Heater not heating properly.

4. Inlet and Outlet Valves leak.

5. Water does not flow.

The heating light turns off but the Pool

Heater heats.

2. The heating light flashing.

A. Filter Pump or Sand Filter does not work. A. Reset-up the Filter Pump or Sand Filter according to the

instructions

S-S-001462

S-S-001462/14.0x21.0cm (#58259GB 英规加热器说明书D版) JS-YF-2012-B-01266/英

Bestway 58259 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bestway 58259

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info