Bedienungsanleitung Beurer IH 25-1 (Seite 14 von 68) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

568807

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

6. Clean the device

For information about this, see “Cleaning and disinfec-

tion” on page 14.

7. Changing the filter

Check the filter after every 10th use. If the filter is very

contaminated or blocked, replace the used filter. If the

filter has become wet, it must also be replaced with

a new one.

Caution

•

Do not try to clean and re-use the used filter!

•

Only use original filters supplied by the manufacturer.

Otherwise, your nebuliser may become damaged or

effective therapy can no longer be guaranteed.

•

Never operate the device without a filter.

To replace the filter, proceed as follows:

Caution

•

First switch off the unit and unplug it.

•

Allow the unit to cool down.

1. Turn the filter cap [5] an-

ti-clockwise and remove

it towards the front.

Note

If the filter remains in the unit when the cap is removed,

remove the filter from the unit using tweezers or similar.

2. Re-insert the filter cap [5] with a new filter. To do

this, insert the cap and turn clockwise until it is felt

to engage.

3. Check that the filter cap is firmly in place.

8. Cleaning and disinfection

Atomiser and accessories

Warning

Observe the following hygiene instructions in order to

avoid any health risks.

•

The atomiser [8] and accessories are intended for

multiple use. Please note that cleaning requirements

differ according to the different application areas.

Notes:

•

The atomiser and accessories must not be me-

chanically cleaned with brushes or similar as this

can cause irreparable damage and the success of

the treatment can no longer be guaranteed.

•

For additional requirements regarding the necessary

hygienic preparations (hand washing, handling of

medicines or inhalation solutions) in high-risk groups

(e.g. cystic fibrosis patients), contact your doctor.

•

Ensure that all parts are properly dried following all

cleaning and disinfection. Residual moisture or water

droplets can result in an increased risk of bacterial

growth.

Preparation

•

Directly following each treatment, all parts of the

atomiser [8] and any accessories used must be

cleaned of medicine residues and contamination.

•

To do this, dismantle the atomiser [8] into its indi-

vidual parts.

•

Remove the mouthpiece [11] from the atomiser.

•

Dismantle the atomiser by turning

the atomiser insert [9] anticlockwise

against the medication container [10]

and pull upwards.

•

The nebuliser is later reassembled in

the reverse order.

Cleaning

Important

Before you clean the unit, always switch it off, unplug

it and let it cool off.

The atomiser and the used accessories such as

mouthpiece, mask, etc. must be washed with hot wa-

ter after each use.

Carefully dry all components using a soft cloth. Once

all components are fully dry, reassemble the atomiser

and place the components in a dry, sealed container

or carry out disinfection.

When cleaning, ensure that all residues are removed.

Never use any substances that may be poisonous

when in contact with the skin or mucous membranes,

or when swallowed or inhaled.

Clean the device using a damp cloth, to which you can

apply a little detergent if necessary.

Do not use abrasive detergents and never immerse the

unit in water.

Important

•

Ensure that no water penetrates inside the unit!

•

Do not put the device or accessories in a dishwasher.

•

Do not touch the unit with wet hands while it is plugged

in; do not allow any water to be sprayed onto the unit.

The unit must be operated only when it is completely

dry.

•

Do not spray any liquids into the ventilation slots. Any

liquid that penetrates into the unit can damage the

electrical parts or other components of the nebuliser

and impair the function of the device.

Condensation, care of the hose

Depending on the environmental conditions, con-

densation may collect in the hose. To prevent against

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer IH 25-1 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beurer IH 25-1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info