Bedienungsanleitung Beurer IH 25-1 (Seite 15 von 68) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Polnisch, Türkisch)

568807

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

bacterial growth and to ensure effective therapeutic

use, this moisture must always be removed. To remove

moisture from the hose, proceed as follows:

•

Remove the hose [7] from the atomiser [8].

•

Leave the hose plugged into the nebuliser [4].

•

Run the nebuliser until all the moisture has been dis-

placed by the flow of air.

•

In the event of significant contamination, replace the

hose.

Disinfection

Follow the steps listed below carefully in order to disin-

fect your atomiser and the accessories. It is advisable

to disinfect the individual components after the last

time they are used each day at the latest.

•

First clean the atomiser and the accessories as de-

scribed under “Cleaning”.

•

The atomiser should be taken apart and placed to-

gether with the mouthpiece and nosepiece in boiling

hot water for at least 10 minutes. Avoid the parts

coming into contact with the hot base of the pot.

•

You can also disinfect the atomiser, the mouthpiece

and the nosepiece with a standard vaporizer. Ob-

serve the manufacturer’s instructions for use for the

vaporizer when doing this.

Note

The face masks and air hose must not be placed in

hot water!

•

Carefully dry all components using a soft cloth.

•

We recommend disinfecting the masks using a retail

disinfectant.

•

Once all components are fully dry, reassemble the

atomiser and place the components in a dry, sealed

container.

Note

Ensure that all parts are thoroughly dried during, and

in particular after cleaning, otherwise there is an in-

creased risk of bacterial growth.

Drying

•

Place the individual components on a dry, clean and

absorbent surface and allow to dry completely (for

at least 4 hours).

Material resistance

•

As with all plastic components, frequent use and

cleaning of the atomiser and the accessories can lead

to a certain amount of wear. Over time, this can alter

the aerosol properties and may eventually affect the

efficiency of therapy. We therefore recommend that

you replace the atomiser after no more than a year.

•

When choosing a cleaning or disinfecting agent, note

the following: Only use mild cleaning or disinfect-

ant agents in the quantities recommended by the

manufacturer.

Storage

•

Do not store the nebuliser in a damp atmosphere

(e.g. in the bathroom) or transport it together with

damp objects.

•

Store and transport the nebuliser away from direct

sunlight.

Storage

•

The device and all accessories, e.g. the nebuliser

and masks, can be stored together in the storage

bag provided.

9. Disposal

In the interest of environmental protection, do not dis-

pose of the device in household waste.

Please dispose of the device in accordance with

EC Directive – WEEE (Waste Electrical and Elec-

tronic Equipment).

If you have any queries, please contact the ap-

propriate local authorities.

10. Troubleshooting

Problem/

Question

Possible Cause/Remedy

The atomiser

produces

little or no

aerosol.

1. Too much or too little medicine in the

atomiser.

Minimum: 0.5 ml, Maximum: 8 ml.

2. Check that the nozzles are not

blocked If necessary, clean the noz-

zle (e.g. by rinsing). Use the atomiser

again.

CAUTION: Only poke implements

through the fine holes from the

underside of the nozzle.

3. The atomiser is not held in an upright

position.

4. The medicine solution is unsuitable

for nebulising (e.g. too thick).

The medicine solution should be

specified by the doctor.

Output is too

low.

Hose kinked, filter blocked, too much

inhalation solution.

Which

medicines are

suitable for

inhalation?

Consult your doctor.

Essentially all medicines that are suit-

able and approved for device-based

inhalation can be inhaled.

Some inhala-

tion solution

remains in the

atomiser.

This is normal and occurs for technical

reasons. Stop inhalation if you hear a

notable difference in the noise of the

atomiser.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beurer IH 25-1 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beurer IH 25-1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info