740637
16
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
10 11
Cleaning by hand
When cleaning by hand, first thoroughly soak the grease filters in hot soapy water, then thoroughly brush off and
most importantly rinse off with clear water. Then allow to drip dry. Do not use aggressive acidic or alkaline cleaning
agents. Use commercially available degreaser sprays to loosen tough grease buildup. The extractor hood needs to
be disconnected from power by pulling the power plug or by disabling the breaker prior to installing and remo-
ving the grease filters.
ACTIVATED CARBON FILTER FOR RECIRCULATING AIR MODE
Activated carbon filters trap odors during recirculating air mode. During normal operation (1 to 2 hours daily),
the activated carbon filters need to replaced approximately twice annually. Matching activated carbon filters are
available on demand in the online shop (see special accessories). Only use original filters. Activated carbon filters
do not contain hazardous materials. They can be disposed in the household waste.
Installing and removing the activated carbon filter
All hoods from the KF series need 2 activated carbon filters. These are screw-mounted in the interior of the hood
on both sides of the blower in front of the intake openings. Proceed as follows to install the activated carbon filters:
1. Start by opening the large front hatch to gain access to the metal filter
2. Then remove the metal grease filter(s)
3. Position the activated carbon filter on both sides of the blower in front of the intake openings
4. The center of the filters has an alignment and a matching insert is on the blower
5. When the filter is seated correctly it can be secured with a small twisting motion
6. You can now reposition the grease filters (see metal grease filters)
Charcoal filters are only used with recirculating
air mode and are not included in the supplied
scope. Contact the manufacturer regarding
recirculating air mode.
CONDENSATE COLLECTION TRAY
Position the included collection tray directly under the
opening in the blower. The tray is simply pushed into
the two small rails. Condensate that forms over time
in the blower can drain through the opening and is
collected in the tray, allowing it to be disposed of
and cleaned with ease..
GB
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Bielmeier BHG39 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info