Bedienungsanleitung Bischoff und Bischoff Centuro S7 (Seite 33 von 71) (Deutsch, Englisch, Französisch, Spanisch)

802030

Zoom out

Zoom in

Vorherige Seite

1/71

Nächste Seite

Bischoff & Bischoff GmbH |28.07.2020 - revision 3

6564

Centuro S7 | Scooter Scooter | Centuro S7

6.3. Batteries

Your scooter is equipped with maintenance-free gel batteries whose

fluid level doesn’t need to be checked.

If your scooter is not used for an extended period, the charger should

be connected about every 4 weeks to prevent damage to the batteries

by deep discharge.

Before embarking on any journey, just check the charge status of

your battery on the battery status display located on your controller.

If the battery status display is in the low range, do not travel longer

distances and promptly connect the battery charger to the scooter. We

recommend connecting the charger to the scooter after every journey

6.3.1. Charging

• Only use approved chargers (of the type specified in the technical

data or supplied by the B+B specialist retailer) to charge the

batteries.

Make sure to also follow the charger’s instructions for use!

• Before switching on the charger, check that the power supply is

230 V.

• First of all, switch the scooter off.

• Connect the charger to the power socket (230 V)

• Check the LED status on the charger. If a red LED illuminates or

flashes, do not start the charging process.

• If the charger is ready for use, connect it to the scooter. The

charging socket is located on the side underneath the ignition lock

(Fig. 40).

• Upper LED is yellow: Charger is switched on

Lower LED is flashing green: Charger ready for use.

- Orange: Charging in process

- Orange/green: Charging in progress, over 80% charged

- Green: Charging complete

- Flashing red: Error, charging not possible

• Once charging is complete, disconnect the scooter from the charger

and unplug the charger from the mains.

6.3.2. Replacing the batteries

Be very careful when working on the batteries. Do not use metal tools,

do not touch the battery terminals and ensure that you follow the

battery manufacturer‘s instructions.

Caution! This work should only be done by a trained

technician. There is danger of fatal injury!

Only use batteries that are approved for this scooter (see Technical

data).

Make sure that the scooter is switched off before starting to replace the

batteries. (See also Section 4.7 - Disassembling for storage).

• The batteries are located underneath the seat of the scooter and

are protected by the housing cover.

• Start by removing the housing cover (Fig 41).

• - Disconnect the plug connections carefully and without using force.

• Undo the screw on the mounting bracket.

• Now remove the batteries (Fig. 43).

• Lift the new batteries into the space provided and connect the

contacts. Make sure to observe the correct colour-coding (red and

black, Fig. 42).

• Reattach the housing cover and the seat.

When the batteries have reached the end of their

life, i.e. cannot be sufficiently charged any more,

they must not be disposed of with the household

waste. When new batteries are purchased, the mo-

bility dealer takes the old batteries and disposes of

them correctly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bischoff und Bischoff Centuro S7 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bischoff und Bischoff Centuro S7

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info